DIRECTIONS FOR USE
CHAIR HEIGHT, SEAT ANGLE & HEIGHT ADJUSTMENT
CAUTION
These adjustments can only be made when no one is on the chair.
The Cable System changes the height of the chair.
To change the cable setting:
1. Lift the seat to relax tension on the cable and remove the “Z” clip from the
seat hole.
2. Insert the “Z” clip into the correct hole and pull back on the seat tube until
the cable is taut. The “Z” clip should lay flat against the seat tube.
Raising and lowering the seat height also changes the seat angle.
A good basic seat position is when the seat is angled downward toward the
front feet, with the back of the seat higher than the front. Lumbar strain can be
reduced by raising the seat height one to two holes.
To change the seat height:
1. Push in the button on the seat tube while raising or lowering the seat.
2. Release the button when the proper height is achieved.
CAUTION
Be sure the push button is fully engaged and the seat
tube is not resting on “Z” clip before sitting on the chair.
ARM REST ADJUSTMENT
CAUTION
The arm rest is designed for the weight of your clients forearms. Do not allow
your clients to push against the arm rest
to lift themselves out of the chair.
To change the arm rest position:
1. Pull the buckle tab to lengthen the strap. Release the cam
lock. Lift or lower the arm rest until your client’s forearms rest
comfortably on the pad and their shoulders are comfortably
rounded.
2. Lock the cam lock and tighten the strap by pulling on it.
SETTING UP YOUR CHAIR
1. Lean your chair forward and lift the back
of the seat until fully open.
2. Remove the plastic covering from the
wheels and feet.
CAUTION
Make sure the cable is fully extended
before sitting on the chair.
3