O2 WAP5884, Руководство пользователя

Страница: 17 / 37

11
the wall, the wireless connection will be established automatically.
You can check “Wireless signal LED” status to understand signal reception level.
Steady light: Excellent, Flash: Good, Fast flash: poor
.
2-1-1b Setup by Web browser
Before you can connect to the repeater and start configuration procedures, your
computer must be able to get an IP address automatically (use dynamic IP address). If
it’s set to use static IP address, or you’re unsure, please refer to ‘
Chapter X: Appendix,
5-1 Configuring TCP/IP on PC
’ to set your computer to use dynamic IP address.
(1)Use Ethernet cable to connect your computer’s Ethernet port and Ranger
Extender’s Ethernet port.
(2)Open the Web Browser on your PC, it will direct to the Web UI page, or you can
input the default IP address http://repeaterxxxx in the address bar.
NOTE:
If the Signal LED is off, it means this place is out of the wireless signal of your
wireless router, please move this repeater closer to wireless router until repeater
device can receive signal from wireless router and extend its signal.
NOTE:
this default SSID ‘repeaterxxxx” is for example, different device may have different
last 4 digits.
The xxxx is the last 4 digits of the MAC number of your Range Extender, Each device
has different MAC number, please find it on your device label.) You can also input
default IP ‘http://192.168.2.254 instead of repeaterxxxx if your PC is not Windows
OS.
Here!