Page
3
of
14
Introduction
The Purpose of this document is to outline the installation and operational procedures and the
operation of the T4000 Alarm Monitor and Controller series, the different variants are listed below.
T4000 - 24PR Pump Controller unit,24vdc powered.
T4000 - 24AL 4 Channel Alarm unit,24vdc powered.
T4000
–
240PR Pump Controller unit 240vac powered
T4000
–
240AL 4 Channel Alarm unit,240vac powered.
T4000-12ALSP 4 Channel Alarm, with Solar power and battery
.
Safety Warnings
To avoid injury please read this manual carefully before installation. Failure to do so could result in injury or
failure of the equipment, this will invalidate any warranties given.
Warning
Installation
Mains Voltage
–
There are exposed electrical conductors inside this appliance of 240vac and
24vdc. This appliance must be installed and serviced by a competent electrical technician to
the current requirements of BS761 and IEEE recommendations. Before servicing this
appliance, normal safe isolation procedures should be implemented.
It is recommended that suitable circuit protection is installed and should include as a
minimum a suitable earth, overcurrent protection, and a residual current protection at
30mA, ideally on its own circuit, but always in accordance with BS7671 and applicable
regulations.
Do not touch any connection terminals while energised.
Do not attempt to service this item when wet, or in high humidity environment.
If the housing of the T4000 becomes damaged, you must shut down and securely isolate this
appliance immediately.
Included Components
T4000 Control Unit
Installation & Operation Manual
Required Components Not Included
Up to 4 x Float Switches or GXX Series Rigid Float Switches
OLE Gauge with Relays
