NZSAT WIND UP, Руководство пользователя

Страница: 8 / 12

7
INSTALLATION DETAILS FOR INSIDE VEHICLE
STEP 9. Install the ceiling plate. The lock - unlock lever must point toward the rear of the vehicle.
Be sure Lock - Unlock lever is pointing towards the rear of the vehicle and hole in
ceiling plate aligns with hole in the ceiling.
STEP 10. Refer to the ROOF THICKNESS CHART (on next page) for the correct length for the directional handle.
NOTE: Pipe or Tube cutter is recommended for cutting the directional handle.
This gives a square cut; a hacksaw does not.
NOTE: Be sure large and small keyways line up in the hub and directional handle!
STEP 11. Insert the directional handle in through hole and up onto the keyed shaft (only fits one way) this is
a great time to re-check the correct length and that the arrow points the same direction as the dish faces!
STEP 12 . Place the Elevation Winding Handle onto hexagonal shaft with spring and
washer fitted with the spring and washer fitted.
CUTTING the HEXAGONAL SHAFT LENGTH
STEP 13.
Flip down handle on the elevation winding handle to see hexagonal shaft,
mark the shaft at the inside bottom edge where it protrudes through the handle.
STEP 14.
Remove the elevation winding handle and cut shaft, reinstall winding handle.
STEP 15.
Re-Install the elevation winding handle and secure with screw.
CAUTION!
After INITIAL INSTALLATION, the antenna SHOULD ROTATE APPROXIMATELY 360°
FROM PARK POSITION.
The pointer on the DIRECTIONAL HANDLE should point towards the ARROW between
Lock/Unlock lever when its parked.