. Manual Signal Reception
The watch is set to pick up the Radio signal automatically at 3:00AM every night. You can also use this feature
to manually search for the radio signal.
1. Holding S1 until the LCD display shows blinking icons of “Antenna and Country”. At the same time, the
second-hand stops at 12 o’clock position.
2. Put the watch nearby a window to get signal. Never put the watch on wrist during signal reception. For
plastic 1-piece un-foldable RC watch, the watch should put on a wooden table with face down as show above
for signal reception.
3. The watch takes 5 to 14 minutes (depends on signal strength) to pick up signal.
4. After reception, the watch will show the time again after the fast running of the second-hand has stopped.
During signal reception, the LCD display shows the signal-strength. It is good to search a location where
signal is the strongest for a good signal reception.
Signal is always good in nighttime but not in daytime. If your watch cannot get signal in daytime, just leave it
nearby a window where signal is strong overnight to get radio signal.
Reception Status Check:
You can check if the watch was able to pick up signal.
1. Press S1 once
If Reception OK
LCD displays Antenna icon with full signal-strength bars
If Reception FAIL
LCD displays Antenna icon only (with NO signal-strength bar)
LCD returns to previous display after 10 seconds
LCD Display selection:
You can set the watch to show either one of the following digital reading on the LCD display.
a. Hour : Minute, or
b. Day-Date or,
c. Month ’Year
To set your favorable digital reading display, push S2 (the lower right button) one after another to select.
EL backlight:
Press S3 once to turn on the EL backlight for around 3 seconds
New York Standard Watch Company
.
www.NewYorkStandardWatch.com
Page 4
2007 EN
NYSW
Instruction Manual
SOHO Series - P103A-01, P103A-02, P201-07, P201-08
(3 hands Analog-Digital Atomic Watch)
