STEP 4: INSTALL THE SENSOR HOUSING
Using the methods shown below, install the Sensor bottom housing on
a clean surface.
OPTION 1: 2-SIDED TAPE
OPTION 2: SCREWS
Notes:
Test the Sensor from desired location before permanent
installation. Installation on metal can reduce transmission range.
Ensure that the device is installed in a dry location away from
water, moisture, and rain.
STEP 5: INSTALL THE MAGNET
Install the magnet in the proper orientation using
2-sided tape or screws. The magnet must be
within 0.75” (1.9 cm) of the Sensor.
If using 2-sided tape, the magnet’s tab can be
removed by snapping the screw tab along the
scored line shown above.
STEP 6: INSTALL THE SENSOR
Once you have confirmed the device is
communicating, insert the sensor top
housing as shown above
PRODUCT FUNCTION AND LED INDICATORS
BUTTON
LED
ACTION
LED
DESCRIPTION
2 TIMES
NETWORK STATUS
JOINED
NOT JOINED
RE-JOIN IN PROCESS
4 TIMES
NETWORK JOIN
SEARCHING FOR NETWORK
DEVICE BEING CONFIGURED
DEVICE JOINED
DEVICE FAILED TO JOIN
8 TIMES
FORCED RE-JOIN
RE-JOIN, SEARCHING FOR PARENT
10 TIMES
NETWORK LEAVE
LEAVE (IF JOINED) AND
AND DEFAULT
DEFAULTS RESTORED
NO ACTION
WRONG BUTTON PRESS
DEVICE BUSY
POWER UP
