POWER BRIDGE
POWER
REMOTE
IN
GND
+12V
FUSE
HIGH
LEVEL
INPUT
LEVEL
MIN
MAX
INPUT
L
R
IN
OUT
PRT
MASTER
MODE
SLAVE
PWR
SPEAKER
NX2000.1
80A
REMOTE
AUTO SENSING
ON
DSP NETLINK
IN
OUT
8
A
4 2 1
PRIMARY AMP
ADDRESS
MULTI-AMP
ADDRESS
OFF
ON
OFF
SW
LEVEL
CONTROL
FUSE
80A
P
OWER CONNECTIONS (NX2000.1)
IMPORTANT!
Before making any connections, disconnect the car’s battery until
the installation is completed to avoid possible damage to the electrical system.
CAR BATTERY
+12V
-
-
+
+
RADIO'S REMOTE
TURN-ON OUTPUT
“REMOTE AUTO SENSING” SWITCH
MUST BE IN THE “OFF” POSITION
FOR THE AMPLIFIER TO TURN ON
IN-LINE POWER FUSE
MOUNTED WITHIN 6"
FROM BATTERY RECOMMENDED
GROUND
(NOT PROVIDED)
Connect the amplifier to the car's battery.
At times, the amplifier will need to draw large levels of current that cannot be provided by
any circuit in the car's fuse box. We recommend using a 2 gauge power wire for your
connections depending on the amplifier and length of the wire. Strip one end of the wire
and connect to the terminal on the amplifier marked “+12V”. Loosen the set screw on
the terminal and insert wire and tighten. Use caution to make sure no stray wire strands
come in contact with surrounding terminals causing short circuits. Run the wire directly
to the positive terminal of the car's battery. Make sure to use an in-line fuse within 6” of
the car's battery to protect the electrical system and amplifier against short circuits
and/or power surges.
Connect the ground terminal of the amplifier to the car's chassis.
For the ground connection, use a 2 gauge wire (black) to connect to the terminal marked
“GND” and then connect it to the car's chassis. Try to keep the length of the cable as
short as possible, preferably less than 6". Make sure that the point on the car where the
connection is to be made is free of paint and dirt.
Connect the remote terminal of the amplifier to a swit12V source
.
Please note:
If you intend to use the high level inputs for your signal connections, we
provide a “Remote Auto Sensing” feature that will automatically turn-on the amplifier
when the high level inputs sense input signal. Please skip this step and see page 12.
This connection allows the amplifier to be turned on and off with the power control of the
radio. If the radio has a REMOTE output terminal, connect it to the amplifier's terminal
marked “REM” (using a 16 gauge wire or heavier). Now when the radio is turned on, the
amplifier will automatically turn on.
When using this wire, the “REMOTE AUTO
SENSING” switch should be in the “OFF” position.
E
N
G
L
IS
H
7
