7
www.nxp.com
SETTING UP THE SYSTEM
1
Insert microSD
Card
Insert the supplied microSD card into the
microSD card socket J8.
2
Connect USB Debug
Cable (Optional)
Connect the micro-B end of the supplied
USB cable into debug port J4. Connect
the other end of the cable to a PC acting
as a host terminal. If needed, the serial-
to-USB drivers can be found at
www.ftdichip.com/FTDrivers.htm
.
Terminal window configuration: 115.2
kbaud, 8 data bits, 1 stop bit, no parity
3
Connect HDMI
Cable
Connect an HDMI cable to the HDMI
connector J7. Connect the other end to
an HDMI capable monitor.
4
Connect Power
Supply
Connect the 5 V power supply cable
to the 5 V DC power jack P1. When
power is connected to the device, it will
automatically begin the boot sequence.
When the boot process is complete, the
Yocto Project operating system will be
displayed on the HDMI monitor.
Note: During the boot process, there will
be operating system status information
scrolling on the terminal window of the
PC (if connected). To work from the
terminal window on the host PC, press
enter at the terminal window to get the
command prompt. Log in as root.
