NXP Semiconductors
UM11038
OM27642 Smart Lock KIT
UM11038
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2018. All rights reserved.
User manual
COMPANY PUBLIC
Rev. 1.1 — 11 October 2018
407611
12 of 38
7. Smart Lock operation
The Smart Lock KIT comes with pre-configured functionality.
7.1 Operating the Smart Lock using the demonstration cards
1) Configure Room 201 by bringing the “Lock Configuration Room 201” card in close
proximity of the module. Wait for lock configuration sequence completion which is
indicated by the RGB LED and on-board buzzer while active.
2) Present “Room 201 ACCESS Guest 1” card or “Room 201 ACCESS Guest 1 re-issued”
card in close proximity of the module. If the card is valid and accepted, LED will light up
green and the buzzer will give a brief beep indicating acceptance. If an invalid card is
used, the LED will light up in red and the buzzer will beep 3 times.
Note: By presenting the “Room 201 Guest 1 re-issued” card, the “Guest 1” card will be
invalidated and not accepted further until you re-configure Room 201 with the respective
configuration card.
3) In order to set the Smart Lock to an alternative room / guest, re-configure the lock to
room 202 / guest 3 with the respective “Lock Configuration Room 202” card. Guest 3 will
be accepted whereas Guest 1 – Room 201 cards are declined.
Fig 12. Set of demonstration cards