BL ID
Hardware Manual
Project Name: Integration Manual Project ID: 62743
3. NTAG I
2
C plus Expolorer Kit OM5569/NT322E: SPECIFICATION
3.1.
Connected Tags Explorer Board OM5569: Specifications
Table 1: Connected Tags Explorer Board OM5569, Rev. 2.0 – specifications:
Low Power Microcontroller
LPC11U24 (Cortex - M0)
Oscillator
Internal oscillator (in LPC11U24) up to 12 MHz, Quartz 12 MHz
On-board sensor
Temperature Sensor
PCT2075
Output/Input
Outputs
3 x LED (orange, green, blue)
Inputs
3 x key
Supported Interfaces (6-pin connector to NTAG I2C Antenna Board)
I2C
I2C-bus interface to up to 100 kBd (Standard mode), up to 400 kBs
(Fast mode)
LCD display
2 x 16 character, WLED backlight, I2C serial communication, 3V3
power supply
Supported Interfaces
USB serial interface
USB 2.0 interface (also supported Usb 1.1), 12 Mbps (USB 2.0 full
speed), micro usb connector
ISP
JTAG interface (10-pin header) for ISP programming with
LPCXpressoBoard
Electrical and Mechanical Specifications
Power Supply
Board is powered from NTAG I2C Antenna Board (from NTAG I2C
tag ic); usb power is used only for powering lcd backlight (20 mA)
PCB Dimensions (L x W x
H)
70 mm x 38 mm x 14 mm
Weight
approx. 22 g
Operating Temperature
0… + 50
C (without condensing)
Operating Humidity
5 … 95% RH
Certificates
CE, FCC
Note:
USB port and JTAG port are used only for writing firmware into LPC11U24 microcontroller
and for debbuging purposes.
SRSt Template 1.0
public
© NXP B.V. 2015. All rights reserved
Doc ID: DOC-XXXXXX
Doc Rev 1.00 Approved — 2015.09.01
10 of 18
