JN517x-DK005
Development
Kit
User Guide
JN-UG-3121 v1.1
© NXP Semiconductors 2017
27
Step 8 Direct a web browser on the PC to the IoT Gateway
a)
Connect the PC to the ZigBee network via the IoT Gateway by specifying the
SSID (name) of the network, which is
Iot_GW_NXP
.
b)
Direct a web browser on the PC to the IoT Gateway’s web interface using either
the default IP address
192.168.2.1
or the URL
http://iot-gw.nxp
.
The first page of the interface displayed in the browser is the “Controls” tab (shown in
the next step).
Step 9 Select a ZigBee network channel and create a network
This step is needed only the first time the demonstration is used.
On the Control tab of the IoT Gateway interface, do the following in the ZigBee
Network area:
a)
Set the radio channel to be used in the ZigBee network to channel 14 by clicking
(ticking) the box labelled “14”.
b)
Create the ZigBee network (initially containing only the Co-ordinator) by clicking
the
Create Network
button.
The ZigBee network will be created on channel 14. A successful network start will be
indicated by the illumination of the green and orange LEDs on the JN5179 USB
Dongle.
You can now add further nodes to the network using NFC commissioning, as
described in
.