NXP Semiconductors
UM10955
JN5179-USB-Dongle User Manual
UM10955
All information provided in this document is subject to legal disclaimers.
© NXP Semiconductors N.V. 2014. All rights reserved.
User manual
Rev. 1.1 — 24 February 2016
8 of 14
host, such as a Windows program, and also communicate with a wireless device or
network.
In order to program an application binary into Flash memory, the JN51xx Production
Flash Programmer can be used, which is described in the JN51xx Production Flash
Programmer User Guide (JN-UG-3099). This programming utility will place the JN5179
into its programming mode. It will then download the program to the Flash memory and
reset the JN5179 device, causing the application to be executed.
4. Compliance statements and documentation
The FCC ID number of the JN5179 USB dongle is XXMJN5179U0
The IC ID number of the JN5179 USB dongle is 8764A-JN5179U0
4.1 FCC statements and documentation
This section contains the Federal Communication Commission (FCC) statements and
documents.
4.1.1 FCC interference statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
FCC caution
: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
WARNING!
FCC radiation exposure statement:
This portable equipment with its integrated antenna complies with FCC’s RF radiation
exposure limits set forth for an uncontrolled environment. To maintain compliance follow
the instructions below;
