NXP Semiconductors JN516x-EK001, Руководство пользователя, Страница: 47 / 86

JN516x-EK001 Evaluation Kit
User Guide
JN-UG-3093 v1.5 © NXP Laboratories UK 2015 47
Step 3 Power on the Linksys router
Connect the power supply to the Linksys router. The unit will automatically power on
(this will also start the JN5168 USB Dongle). The power LED will first flash and then
the central LED will flash. The unit is ready when the central LED stops flashing and
remains illuminated.
Since the JN5168 USB Dongle will also be the Co-ordinator of the WPAN, this device
will create a network, for the moment consisting only of the Co-ordinator - the rest of
the network will be formed later.
Step 4 Set up the rest of the demonstration system
Continue the set-up of the Smart Home Demonstration by following the procedure in
Section 3.3 .
3.3 Setting Up and Operating the Demo System
This section describes how to set up and operate the Smart Home Demonstration
(and assumes that you have set up the Border-Router as detailed in
Section 3.2 ).
Step 1 Access the JenNet-IP Border-Router Configuration interface from the PC
a) Launch a web browser on the PC.
b) Access the JenNet-IP Border-Router Configuration interface on the Border-
Router by entering its IP address into the browser:

In the case of the Raspberry Pi board, this will the DHCP lease address
obtained in Step 5 in
Section 3.2.1

In the case of the Linksys router, this will be 192.168.11.1
c) On the resulting web page, log in with username
root
and password
snap
.
Step 2 Display the ‘whitelist’ of WPAN nodes in the interface on the PC
In the interface, select the JenNet-IP tab and then select the Whitelist sub-tab.
Normally, this sub-tab shows a list of the detected WPAN nodes, identified by their
IPv6 addresses, as illustrated in the screenshot below. Those nodes that are ticked (in
the checkbox on the left-hand side) are in the whitelist and so are allowed into the
network.
Note: The are differences between the demonstration
software pre-programmed in the evaluation kit
components and the software supplied in the
Application Note
JenNet-IP Smart Home (JN-AN-1162) .