NXP Semiconductors FS5600, Руководство пользователя, Страница: 10 / 16

NXP Semiconductors
UM11642
KITFS5600SKTEVM evaluation board
5. Freedom board Firmware is successfully loaded. Disconnect and reconnect the USB
cable into the USB port. Open the previously installed NXPGUI. The “Start” button on
the top-left corner must be activated.
6. If only the NXPGUI firmware needs to be updated, then start from step 4 above. The
PC detects
FRDM_K82FD
.
6 Configuring the hardware for startup
Figure 3. Typical initial configuration
Figure 3 presents a typical hardware configuration incorporating the development board,
power supply and Windows PC workstation.
To configure the hardware and workstation as illustrated in
Figure 3 , complete the
following procedure:
1. Ensure that jumpers are in the default positions as shown in
Section 4.2.1 "Jumpers" .
2. With the USB cable connected to the PC and the USB port in the freedom board
K82F, apply power to the evaluation board by applying 12 V between J21 and J25.
3. Press Reset on the Freedom board to make sure that the board is recognized.
4. Run the installed NXPGUI application from the Start menu or the installation folder.
UM11642 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2021. All rights reserved.
User manual Rev. 1 — 23 July 2021
10 / 16