4
5
freescale.com
Quick Start Guide
2
Configure the
Hardware
Install the included battery into the VBAT
(RTC) battery holder. Then, connect one
end of the USB cable to the PC and the
other end to the power/OSJTAG mini-B
connector on the TWR-K60D100M
module. Allow the PC to automatically
configure the USB drivers if needed.
3
Tilt the
Board
Tilt the board side to side to see the LEDs
on D7, D8, D9 and D11 light up as it is
tilted. While the board is held flat, touch
the pads on D7, D8, D9, D11 to toggle the
LEDs.
4
Play the
Memory Game
Press SW2 to play a memory recall game
using the touch pads D7, D8, D9 and
D11. A sequence will light up, then press
the touch pads in the order flashed. If an
incorrect sequence is touched or too much
time has elapsed, the LEDs will blink rapidly
and the game will reset.
Press SW1 to return to the accelerometer
demo.
Step-by-Step
Installation Instructions
Install the Software
and Tools
Install the P&E
Micro Kinetis Tower toolkit.
The toolkit includes the
OSJTAG and USB-to-serial
drivers. These can be found on line at
1
• MK60DN512VMD10 MCU (100 MHz ARM
®
Cortex
®
-M4 core, 512 KB flash, Ethernet,
USB FS OTG, encryption, 144 MAPBGA)
• Integrated open source JTAG (OSJTAG) circuit
• MMA8451Q 3-axis accelerometer
• Four user-controlled status LEDs
• Four capacitive touch pads and two mechanical pushbuttons
• General-purpose TWRPI socket (Tower plug-in module)
• Potentiometer, SD card socket and coin-cell battery holder
In this Quick Start Guide, you will learn how to set up the TWR-K60D100M module
and run the default demonstration.
