© Freescale Semiconductor, Inc., 2004. All rights reserved.
Freescale Semiconductor
Quick Start Guide
Rev. 0.1, 06/29/2004
DEMO9S12NE64 Demo
Quick Start Guide
Introduction
This kit and guide contains
everything you need to get started. You will connect the board to your PC, run
the pre-programmed Startup Demo, install the correct version of CodeWarrior, and load the
MC9S12NE64 demo game called “The Connector.” Source code for both demos and the Serial Monitor
are provided on the MC9S12NE64 Resource CD.
describes the power barrel connector
requirements. Please follow it closely, mainly to avoid damaging the board by applying too much power
.
Please refer to the DEMO9S12NE64 User’s Guide on the MC9S12NE64 Resource CD provided for
additional information about the board.
Figure 1. Power Barrel Connector Requirements
Connect the DEMO9S12NE64 to Your Computer and Apply Power
1.
Connect one end of the Crossover Ethernet cable provided to the J1 Ethernet Port of the DEMO
board. Connect the other end to the Ethernet Port of your host PC.
2.
Connect the 9-pin serial cable provided to the SCI port of the DEMO board. Connect the other end
to a COM port on your host PC.
3.
Plug the wall plug power supply provided into a power outlet and install the barrel connector into
the power jack on the DEMO board. If you are not using the original power adapter supplied, please
refer to the specs in
.
4.
Set the DEMO board SW3 switch to position 1, so that you can immediately start running the
Startup Demo.
5.
Apply power to the board. The PWR LED in the bottom left corner of the board (oriented with the
power connector at the bottom left) should come on. Either LED1 or LED2 (not both) should also
turn on, indicating that you are in Test1 of the Startup Demo.