NXP Semiconductors FRDM-HB2000FEVM, Руководство пользователя, Страница: 21 / 37

NXP Semiconductors
KTFRDMHB2000FEVMUG
FRDM-HB2000FEVM evaluation board
KTFRDMHB2000FEVMUG All information provided in this document is subject to legal disclaimers. © NXP B.V. 2016. All rights reserved
User guide Rev. 1.0 — 5 July 2016
21 / 36
6.1.2 Step-by-step instructions for setting up the hardware for use with a
function generator
This section describes how to configure the FRDM-HB2000FEVM for use with a
function generator. The same connections apply if the board is connected to a
microcontroller instead of a function generator. See the board description Section 4.4
"Board description" , the schematic Section 7 "Schematic" and the MC33HB2000 data
sheet, to configure the board for use in a specific environment.
1. Connect the function generator to the EX_IN jumper, with one channel attached to
each pin.
2. Change the board jumper connections, as shown in Figure 14 .
3. With the power switched off, attach the DC power supply to the VBAT and GND screw
connector terminal (J20) on the evaluation board.
4. Connect the load to the screw terminal (J21).
Figure 14 illustrates the hardware configuration.
Channel 1 Channel 2
Refresh Setting 2
Setting 1
Setting 1
Setting 2
Setting 3
Setting 4
Setting 5
Setting 6
Setting 7
Setting 8
Setting 1
Setting 2
Setting 3
Setting 4
Setting 5
Setting 1
Setting 5
1 2 3
4 5 6
7 8 9
* 0 #
Input 1 Input 2 Input 3
High Low
High
Setting 2
Setting 2
Setting 2
High
Low
Medium
Low
Medium
Low
High
Select
All
De-Select
All
In 1 In 2 In 2
PWR
Line Out Aux Power
Brushed DC Motor
Function Generator (or MCU)
5 - 40 V Power Supply, 20 A
Figure 14. FRDM-HB2000FEVM configured for use with a function generator
6.2 Installing and using SPIGen
The latest version of SPIGen supports the MC33HB2000 and is designed to run on any
Windows 8, Windows 7, Vista, or XP-based operating system. To install the software, do
the following: