NXP Semiconductors EasyEVSE EV, Руководство пользователя

Страница: 39 / 64

Figure 53. OM-SE050ARD jumper setup
By default, the other jumpers are ready in the desired position out of the box. For details about the OM-SE05xARD hardware and
jumper functions, see
OM-SE050ARD hardware overview
(document AN12395 ).
If you need extra shunts or jumpers for SE050, you can use the extra shunts in the bag that comes in the TWR-KM3x box.
7.5 CLEV6630ARD setup
To ensure compatibility of the board with other boards, cut and remove 3 of its pins and wire J6 P5 to J7 P16 and J6 P6 to J7 P14.
See
Table 5 for details.
Table 5. CLEV6630ARD setup
Pin to cut and remove Pin function Reason Workaround
Header J11 P1 Not connected
Mechanical interference with
OM-SE050ARD J24 P5.
Not necessary.
Header J12 P8 CLRC6630 IRQ
False triggering of the
NFC reader library due to
incompatible logical levels.
Any toggle in the IRQ pin can
trigger the pin INT1_Combo
signal on pin J22 P5 of the
i.MX RT106x EVK. After cutting and removing
the pin, use a cable to wire
CLC6630ARD J6 pin 5 to J7
pin 16.
This will reconnect the IRQ pin
with the i.MX RT106x.
Header J12 P6 CLR6630 nPDOWN
Undesired hold-on reset of
either the CLRC33 or the i.MX
RT106x Ethernet module. After cutting and removing
the pin, use a cable to wire
Table continues on the next page...
NXP Semiconductors
Board setup, wiring, and assembly
NXP EasyEVSE EV Charging Station Development Platform User Guide, Rev. 0, 18 March 2022
User Guide 39 / 64