EXTERNAL USE
5
Step-by-Step Installation Instructions
1
Install Software and Tools
Install S32 Design Studio IDE for Power Architecture.
S32 Design Studio for Power
See Software Installation Guide (SWIG) for detailed procedure
2
Connect the USB Cable
Connect one end of the USB cable to the PC and the other end to
the micro-B connector on the DEVKIT-MPC5748G board. Allow the
PC to automatically configure the USB drivers.
3
Observe the Default Program reaction
The pre-loaded example project utilizes the
DEVKIT-MPC5748G
user push button (SW2) and the user LEDs. Once the board is
plugged in, LEDs will blink in default pattern. Press push button to
switch between the two different patterns. Use Potentiometer to
change blinking speed. (Clock is configured to PLL running at 160
MHz)
4
Learn More About the DEVKIT-MPC5748G
Read release notes and documentation on the
nxp.com/DEVKIT-MPC5748G
nxp.com/MPC5748G
In this quick start guide, you will learn how to set up the
DEVKIT-MPC5748G
board and run the default program.
J11
3 1
Jumper Setting:
2-3: USB powered
5V Supply, through
OpenSDA interface