NX-VCH8 Specifications
Power Handling:
150 watts RMS per channel
(suitable for use with 300 watt
per channel rated
receivers/amplifiers)
Frequency Response:
20 Hz - 22kHz (+0dB, -0dB)
Wire size acceptance:
2 or 4 conductor, stranded,
16 AWG to 14 AWG
Dimensions:
6
7
/
8
˝ (175mm) W x
3
3
/
32
˝ (76mm) H x
1
3
/
16
˝ (30mm) D
including connectors
Mounting Hole Diameter:
7
/
32
˝ (5.5mm)
Maximum Number of Volume
Control/Speaker Connections:
8 pairs
Designed for use with Class 2
wiring only
16648 North 94th Street
Scottsdale, AZ 85260
1-800-733-0008
www.nxgtech.com
NXG One-Year Limited Warranty
If the NXG product proves to be defective in workman-
ship or materials within one year from the date of the
original customer’s purchase, we will, at our option,
repair or replace the defective product.
Limitation of Implied Warranties
Any implied warranties, including warranties of mer-
chantability and fitness for a particular purpose, are
limited in duration to the length of this warranty.
Exclusion of Certain Damages
NXG’s liability for any defective product is limited to
repair or replacement of the product at our option.
NXG shall not be liable for incidental or consequential
damages of any kind or character because of product
defects. Some states do not allow limitations on how
long an implied warranty lasts and/or do not allow the
exclusion or limitation of incidental or consequential
damages, so the above limitations and exclusions may
not apply.
This Warranty Does Not Cover:
• Damage caused by abuse, accident, misuse, negli-
gence, or improper operation.
• Any product whose serial number has been altered,
defaced, or removed.
• Products that have been altered or modified.
• Normal wear and maintenance.
• Damages caused by shipping. (All claims for shipping
damage must be made with the carrier.)
Warranty Service
Warranty service must be performed by an authorized
service center, usually a NXG dealer or its authorized
agent. You may obtain a list of authorized service cen-
ters by contacting NXG. All warranty repairs must be
accompanied by the original bill of sales. No other doc-
ument is acceptable or is required. This warranty gives
you specific legal rights, and you may also have other
rights which vary from state to state.
NXG reserves the right to revise specifications without notice.
Fig. 3
2. Make sure to use properly
rated, polarity identified
speaker wire from the
receiver/amplifier to the
NX-VCH8, then run wires to
the volume control/speaker
locations. Be sure to leave
enough extra wire to make
connection to the terminal
blocks.
3. Strip about 1/4˝ of insulation
from the end of each wire.
Connect the exposed
bare wire to the removable
connector plugs using a small
screwdriver as shown in Fig. 2.
4. Pay close attention to the
identification markings on the
connectors when inserting
each wire to maintain proper
polarity throughout the system
from your amplifier to the
NX-VCH8 hub, and out to your
volume controls and speakers.
Be sure to twist the loose
strands of each wire together
into a tight bundle when
inserting it into the small
opening of the connector to
prevent loose strands from
touching each other.
5. Install the connector plugs
back on the NX-VCH8 as
shown in Fig. 3.
Fig. 2
