Frequently Asked Questions
Can I use flasher/emitters that I have already installed in the system to
connect to the NX-RF200?
Yes, the flashers are compatible if they use 3.5mm mono mini plugs with
the same polarity (Tip is data, sleeve is ground).
I’m getting inconsistent operation regardless of flasher level or
position.
Some components are easily overloaded with IR from nearby flashers.
Prevent IR from affecting the problem component from other flashers or
the front panel blaster by setting the device to a specific IR Line Output
instead of ALL, then adjust the Line Output.
I have a row of identical TVs. I’ve correctly set the flasher outputs using
the Editor software, yet when I send a command to one of them, the TV
next to the selected TV also responds. How do I stop this?
First, check the RF ID#, if the RF ID# is set to 0, IR routing does not work.
Second, set the RF ID# from 1-9 or A-F on both the remote control and the
rear of the NX-RF200. Third, check that the flasher level is set to the mini-
mum necessary. Fourth, check that the emitter is facing the component.
Specifications
Power Supply:
9V 300mA
IR Flasher Line Outputs:
3.5mm Mono Mini Jack
RF Frequency:
418MHz
NX-RF200 Base Station
12
NX-RF200_Manual.qxd 10/27/08 12:48 PM Page 15
