H. WARRANTY
INFORMATION
NX-BAS-500 Powered
Subwoofer Limited Warranty
If the NXG speaker system proves to be defec-
tive in workmanship or materials within two
years from the date of the original customer’s
purchase, we will, at our option, repair or replace
the defective product.
Limitation of Implied Warranties
Any implied warranties, including warranties of
merchantability and fitness for a particular pur-
pose, are limited in duration to the length of this
warranty.
Exclusion of Certain Damages
NXG’s liability for any defective product is limited
to repair or replacement of the product at our
option. NXG shall not be liable for incidental or
consequential damages of any kind or charac-
ter because of product defects. Some states do
not allow limitations on how long an implied
warranty lasts and/or do not allow the exclusion
or limitation of incidental or consequential dam-
ages, so the above limitations and exclusions
may not apply.
This Warranty Does Not Cover:
• Damage caused by abuse, accident, misuse,
negligence, or improper operation.
• Any product whose serial number has been
altered, defaced, or removed.
• Products that have been altered or modified.
• Normal wear and maintenance.
• Damages caused by shipping. (All claims for
shipping damage must be made with the
carrier.)
Warranty Service
Warranty service must be performed by an
authorized service center, usually an NXG
speaker systems dealer or its authorized agent.
You may obtain a list of authorized service cen-
ters by contacting NXG. All warranty repairs
must be accompanied by the original bill of
sales. No other document is acceptable or is
required. This warranty gives you specific legal
rights, and you may also have other rights which
vary from state to state.
NXG reserves the right to revise speaker system
specifications without notice.
8
©2012 NXG
G. TROUBLESHOOTING
& SERVICE
Before returning your NX-BAS-500 for service, you
can save time (and often embarrassment) by checking
for a few problems that are most often encountered.
Power light is not lit. No sound.
1.
Is your NX-BAS-500 plugged in to a live AC wall
socket?
2.
Is the power switch on?
3
. Has the NX-BAS-500 overheated and shut off
temporarily?
No sound from either set of speakers.
1.
Are your other components turned on?
2.
Is the receiver, preamp, or TV set to the appro-
priate input and is that sound source playing?
3.
Do you have an unconnected tape monitor
selected?
4.
Is the NX-BAS-500 correctly connected to your
receiver, preamplifier, integrated amplifier, or TV
and turned on?
Sound comes from main speakers but not the
subwoofer
1.
Is the NX-BAS-500 turned on (power light in the
green mode) and VOLUME control turned up?
2.
Check the speaker connections for small strands
of wire touching both terminals.
3.
Some digital receivers only send a sub out signal
when in the movie or digital mode. In the 2 channel
(stereo music) mode, no sub out signal is sent to
the sub.
You may need to set your main speakers to “small”
mode in your receiver setup to get the receiver’s
subwoofer output to turn on. Check your receiv-
er’s owner’s manual for subwoofer operation.
4.
For digital receivers – make sure the subwoofer
is “ON” and the subwoofer level is set to “0dB”
or greater.
Sound comes from the subwoofer but not your
main speakers
1.
• Confirm that the power amplifier is turned on.
• Check the RCA patch cord
• Check the speaker wire connections between
the receiver and main or satellite speakers.
Bass is muffled or weak
1.
Check speaker wire polarity of all connections.
2
. Reposition your subwoofer. At some points in
the room, its output may be cancelled by the
geometry of the room. Moving the NX-BAS-500
can eliminate this problem.
Please refer to Item 10 in the Safety Instructions
for conditions that ALWAYS require service by
qualified personnel.
If you have tried all the above and still cannot
get the NX-BAS-500 to operate properly,
consult your dealer or contact NXG tech support
Amplifier Power
500 watts – Dynamic Power
System Design
Vented Enclosure
Woofer
12˝ high-excursion, forward-firing
woofer with rose-gold injection-molded
metallic-anodized cone and
Polymeric surround
Sensitivity (1 Watt @ 1 Meter)
90 dB
Frequency Response
18Hz - 120Hz Variable
Input Options
LFE/RCA Line Level
Input Impedance
LFE/RCA Line Level: 22K ohms
Controls
Power, Volume, Auto-On, Phase,
Crossover Frequency
Variable Crossover
40 - 120Hz
Video-Shielded
No
Dimensions
17
5
/
8
˝ H x 14
3
/
4
˝ W x 17
5
/
8
˝ D
(448 mm H x 375 mm W x 448 mm D)
Finish
Satin Black
Net Weight
40 lbs. (18 kg)
F. SPECIFICATIONS
Caring for Your
NX-BAS-500
The NX-BAS-500 enclosure is finished
in a very high-quality polyurethane fin-
ish that is both attractive and excellent
protection for the wood cabinet. To
remove dust, finger prints, and light
water marks you can use a soft, dry
cloth. Never use a solvent like paint
thinner, Ketone, gasoline, MEK, lighter
fluid, etc., on the enclosure surface or it
will cause permanent damage.
Scottsdale, AZ
email: [email protected]
web: nxgtechnology.com
