Last Update: 5/22/12
Page 10 of 10
The final end product must be labeled in a visible area with the following:
The Industry Canada certification label of a module shall be clearly visible at all times when installed in the
host device, otherwise the host device must be labelled to display the Industry Canada certification number
of the module, preceded by the words “Contains transmitter module”, or the word “Contains”, or similar
wording expressing the same meaning, as follows:
Contains transmitter module
IC: 7361A-P1453
, where
7361A-P1453
is the module’s certification number
The integrator is responsible for final product compliance with IC ICES-003 and FCC Part 15, Sub. B –
Unintentional Radiators.
This device has been designed to operate with the antenna listed in above table, and having a peak gain of
3.84dBi @ 2.4GHz,, Antennas not of the same type and having a higher gain specified above are strictly prohibited
for use with this device. The required antenna impedance is 50 ohms.
Europe—EU Declaration of Conformity and Restrictions
Hereby,
NVIDIA Corporation
，
declares that this equipment complies with the essential requirements and
other relevant provisions of Directive 1999/5/EC.
If the module is incorporated into an OEM product, the OEM product manufacturer must ensure compliance
of the final product to the European Harmonised EMC, and low voltage/safety standards. A Declaration of
Conformity must be issued for each of these standards and kept on file as described in the R&TTE Directive.
The final product must not exceed the specified power ratings, antenna specifications and installation
requirements as specified in this user manual. If any of these specifications are exceeded in the final
product then a submission must be made to a notified body for compliance testing to all of the required
standards.
Important Note:
In Europe the regulations for the 2.4GHz frequency band are only harmonized for devices
with an e.i.r.p. of less than 10mW (10dBm). In the case of e.i.r.p. of more than 10mW the manufacturer or
his authorized representative established within the community or the person responsible for placing the
equipment on the market shall notify the national authority responsible in the relevant Member State for
spectrum management of the intention to place such equipment on its national market. This notification shall
be given no less than four weeks in advance of the start of placing on the market.
Because of this, NVIDIA recommends that the user limits the output power to 10mW (10dBm) for Europe to
avoid having to deal with the local authorities for spectrum management of each relevant member state
Caution: Exposure to Radio Frequency Radiation.
To comply with RF exposure compliance requirements, This device must not be co-located or operating in
conjunction with any other antenna or
transmitter.
Taiwan - NCC Statement
根據交通部低功率管理辦法規定：
第十二條
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原
設計之特性及功能。
第十四條
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，至無干擾時方
得繼續。並改善前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、
科學及醫療用電波輻射性電機設備之干擾。
