5
Chapter 2 Hardware Installation
2-1 About Intel LGA775 CPU
This motherboard provides a 775-pin surface mount, LGA775 Land Grid Array socket,
referred to as the LGA775 socket supports Intel Core family processor in the 775 Pin package
utilizes Flip-Chip Land Grid Array (FC-LGA) package technology.
The CPU that comes with the motherboard should have a cooling FAN attached to prevent
overheating. If this is not the case, then purchase a correct cooling FAN before you turn on
your system.
WARNING!
Be sure that there is sufficient air circulation across the processor’s heat
sink and CPU cooling FAN is working correctly, otherwise it may cause
the processor and motherboard overheat and damage, you may install an
auxiliary cooling FAN, if necessary.
To install a CPU, first turn off your system and remove its cover. Locate the LGA775
socket and open it by first pulling the level sideways away from the socket then upward to a
90-degree angle. Insert the CPU with the correct orientation as shown below. The notched
corner should point toward the end of the level. Because the CPU has a corner pin for two
of the four corners, the CPU will only fit in the orientation as shown.
CPU LGA775 Socket
Colden Arrow
LGA775
When you install the CPU into the LGA775 socket, there’s no force required CPU insertion;
then presses the level to locate position slightly without any extra force.
2-2
Install
Memory
This motherboard provides two 240-pin DDR DUAL INLINE MEMORY MODULES
(DIMM) sides for DDR memory expansion available from minimum memory size of 128MB
to maximum memory size of 4.0GB DDR SDRAM.
Valid Memory Configurations
Bank
240-pin DDR DIMM
PCS Total Memory
Bank 0, 1 (DIMM1) DDRII 800/667/ 533 DDR DRAM Module
X1
128MB
∼
2.0GB
Bank 2, 3 (DIMM2) DDRII 800/667/553 DDR DRAM Module
X1
128MB
∼
2.0GB
Total
System Memory (Max. 4.0GB)
X2
128MB
∼
4.0GB
