1
m
Connect to
grounding system
8
5
3
1
2
8
8
5
To bend down conductor:
follow chapter 5.3.3 from
NFC 17-102 standard
3
8
2
6
8
Connect to
grounding system
7
4
1
8
ITEM
PART No.
QTY.
DESCRIPTION
1
SIXXI
1
ESE Terminal
2
SIM28A2
1
SIM STAINLESS STEEL MAST
3
SIM33B3
1
SIM STAINLESS STEEL MAST
4
TMCSS (702165)
2
PIPE CLAMP
5
ALOF1GS (702175)
2
MAST SUPPORT
6
CABTIESS (701420)
12
CABLE TIE
7
DOWN CONDUCTOR CLIP
3 PER METER
8
COPPER TAPE/CABLE
DOWN CONDUCTOR
Three every 1m
TECHNICAL SUPPORT
www.nVent.com
IP8504_A
2 OF 7
INSTRUCTION SHEET
nVent, nVent CADDY, nVent ERICO Cadweld, nVent ERICO Critec, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by
nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change
specifications without prior notice.
WARNING:
nVent products shall be installed and used only as indicated in nVent product instruction sheets and training materials. Instruction sheets are available at
1.
www.nVent.com and from your nVent customer service representative.
nVent products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be completely followed to ensure proper and safe installation and performance.
3.
Improper installation, misuse, misapplication or other failure to completely follow nVent's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and/or death, and void your warranty.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
System 1000 Cantilevered 4 meters above building
© 2019 nVent All Rights Reserved
1
m
