NuWaves NUPOWER C30R01, Руководство пользователя

Страница: 9 / 12

NuPower TM C30R01 User Manual
Rev 1.0
8
4 HARDWARE INTERFACE
• The RF Input connector is SMA (female).
• The RF Output connector is SMA (female).
• The pin-out definitions for the 9 pin Micro-D socket connector are provided in Table 5. In a typical
installation, the PA module is mated to a host controller board via a cable harness.
The RF Out SMA connector is the antenna connection. This connection should always
be loaded into 50 Ω , otherwise the PA could be damaged.
4.1 INTERFACE CABLE HARNESS
The cable harness that connects the host controller to the 9 pin Micro-D connector of the NuPower
C30R01 is made up of 9 wires.
Table 4: NuPower C30R01 Interface Pin-Out Definitions
Pin No. Pin Name I/0 Description
3, 4, 5 V Supply I Primary Power (+28 VDC)
1, 2, 6, 8 GND I Signal and Power Ground
7 Temp Flag 0 Over-temp Indicator
0V = temperature fault
+5V = no fault
9 RF Enable I Transmit Control
0V or GND = RF On
+5V or NC = RF Off
Figure 4: Micro-D Socket Locations