M031/M032
Jan 28, 2019
Page
5
of 26
Rev 1.00
NUT
INY
-S
DK
-M
03
1
US
E
R
MA
NU
A
L
2
NUTINY-SDK-M031TC INTRODUCTION
NuTiny-SDK-M031TC uses the M031TC1AE as the target microcontroller. Figure 2-1 is NuTiny-
SDK-M031TC for M031 series, the left portion is called NuTiny-SDK-M031TC and the right
portion is Debug Adaptor called Nu-Link2-Me.
NuTiny-SDK-M031TC is similar to other development boards. Users can use it to develop and
verify applications to emulate the real behavior. The on board chip covers M031 series features.
The NuTiny-SDK-M031TC can be a real system controller to design user
’s target systems.
Nu-Link2-Me is a Debug Adaptor. The Nu-Link2-Me Debug Adaptor connects your PC's USB port
to your target system (via Serial Wired Debug Port) and allows you to program and debug
embedded programs on the target hardware. The Nu-Link2-Me also supports VCOM function,
which gives users more flexibility when debug. To use Nu-Link2-Me Debug adaptor with IAR or
Keil, please refer to “Nuvoton NuMicro
®
IAR ICE driver user manual “or Nuvoton NuMicro
®
Keil
ICE driver user manual” in detail. These two documents will be stored in the local hard disk when
the user installs each driver. To use Nu-Link2-Me VCOM function, please refer to Chapter 5.
Reset Botton
(SW1)
I/O LED
Power LED
Extended Connector
(JP3/JP6)
ICE Controller
USB Connector
(ICE J1)
ICE Controller
Target Chip
MCUVCC:
1.8V, 3.3V or 5V
(JPR1)
VDD
(JP1)
GND
(JP2)
VCOM
Enable
Extended Connector
(JP4/JP5)
ICEVCC:
1.8V or 3.3V
(JPR1)
Offline
Programming
Button
Figure 2-1 NuTiny-SDK-M031TC (PCB Board)
