NuMaker-M2351SF
Sep.
24, 2019
Page
15
of 35
Rev 1.00
N
UMA
K
E
R
-M2
35
1
S
F
U
S
E
R MA
NUA
L
Ma
k
er Nu
-m
be
d
NUC
47
2
Us
er Man
ua
l
System Configuration
2.5.1 VIN Power Source
Table 2-3 presents the Vin power source.
Connector
Net Name in
Schematic
Comment
NU1 pin8
NU1_VIN
Board external power source, with voltage range from 7
V to 12 V. The voltage regulator UP2 converts the NU1
pin8 input voltage to 5 V and supplies it to NuMaker-
M2351SF.
Table 2-3 Vin Power Source
2.5.2 5 V Power Sources
Table 2-4 presents the 5 V power sources.
Connector
Net Name in
Schematic
Comment
ICEJ3
USB_HS_VBUS
ICE USB connector supplies 5 V power from PC to
M2351SF platform and Nu-Link2-Me.
J2
USB_VBUS
USB connector on NuMaker-M2351SF supplies 5 V
power from PC to M2351SF platform and Nu-Link2-
Me.
NU1 pin5
NU1_5VCC
ICEJ3, J2 or NU1 pin8 supplies 5 V power to NU1
pin5. NU1 pin5 supplies 5 V power to target chip or
Arduino adapter board.
Note:
M2351SF operating voltage range is from 1.8 V
to 3.6 V. Do not switch SW2.1(NU1 5VCC) to ON.
Table 2-4 5V Power Sources
2.5.3 3.3 V Power Sources
Table 2-5 presents the 3.3 V power sources.
Voltage
Regulator
5V Source
Comment
ICEUP1
USB_HS_VBUS
ICEUP1 converts USB_HS_VBUS to 3.3 V and
supplies 3.3V to M2351SF platform
or ICE chip.
UP1
USB_VBUS
UP1 converts USB_VBUS to 3.3 V and supplies 3.3 V
to M2351SF platform.
Note:
SW2.2(NU1 3VCC) should be switched to ON.
UP1
NU1_5VCC
UP1 converts NU1_5VCC to 3.3 V and supplies 3.3 V
to M2351SF platform.
Note:
SW2.2(NU1 3VCC) should be switched to ON.
Table 2-5 3.3 V Power Sources
