background image

Precautions 

For U.S. Models

Note to CATV system installer:

This reminder is provided to call the CATV system 
installer’s attention to Section 820-40 of the NEC, 
which provides guidelines for proper grounding 
and, in particular, specifies that the cable ground 
shall be connected to the grounding systems of the 
building, as close to the point of cable entry as 
practical.

FCC Information for the User
Caution:

Changes or modifications by the user that are not 
expressly approved by the party responsible for 
compliance could void the user’s authority to 
operate the equipment.

NOTE:

 

This equipment has been tested and found to 
comply with the limits for a class B digital device , 
pursuant to part 15 of the FCC rules. These Limits  
are designed to provide reasonable protection 
against harmful interference in a residential 
installation. This equipment generates, uses and 
can radiate radio frequency energy and, if not 
installed and used in accordance with the 
instructions, may cause harmful interference to 
radio communications. However, there is no 
guarantee that interference will occur in a particular 
Installation. If this equipment does cause harmful 
interference to radio or television reception, which 
can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the 
interference by one or more of the following 
measures:

1)

 Reorient or relocate the receiving antenna.

2) 

Increase the separation between the equipment 

and the receiver.

3)

 Connect the equipment into an outlet on a circuit 

different from that to which the receiver is 
connected.

4) 

Consult the dealer or an experienced radio/TV 

technician for help.  

GROUND
CLAMPS

ELECTRIC
SERVICE 
ENTRANCE

ANTENNA 
DISCHARGE UNIT 
NEC  SECTION
810-20
GROUNDING 
CONDUCTORS

GROUND CLAMPS

POWER SERVICE 
GROUPING ELECTRODE
SYSTEM NEC ART 250
PART H 

NEC NATIONAL ELECTRICAL CODE 

ANTENNA 
LEAD-IN 
WIRE

Warranty

NUVO Technologies warrants this product to be free of defects in 
workmanship or materials for a period of three (3) years from the 
original date of purchase.  This warranty applies to the original 
purchaser only and is not transferable. This warranty is subject to 
the following conditions and exclusions.

-Defects caused by wear and tear, misuse, or neglect are 
not covered by this warranty.
-This warranty will be void if:

a. The unit has been altered or modified.
b. The serial number has been removed or 
    defaced. 
c. Original purchase is not from an Authorized 
    NUVO Dealer.
d. The warranty card is not completely filled out and 
    mailed within 10 days of the original purchase.

Neither NUVO Technologies nor NUVO dealers are liable for any 
incidental or consequential damages resulting from any defect in or 
failure of NUVO Technologies products. This warranty gives the 
original owner of NUVO Technologies products specific legal rights, 
and he or she may also have other rights which vary from state to 
state. This warranty is expressly in lieu of all other agreements and 
warranties, expressed or implied, except as may be otherwise 
required by law.

Содержание NV-T3













Отзывы: