background image

3015

Instruction manual

Starry

EN

Audio baby monitor with nightlight projector

3015

Thank you for purchasing NUVITA 3015 TULE STARRY AUDIO BABY MONITOR. Our product has been 

manufactured and checked under the strictest possible quality control to ensure that each monitor leaves the 

factory in perfect condition. In the unlikely event you find any defects or have any problem, please contact our 

dealer or service center.
Please read this manual carefully to obtain maximum performance and extended service life from the unit.

Nuvita TULE-equipped products can automatically select free channel or hop to free channel during 

communication to avoid interference from other electronic devices. In addition, Nuvita TULE technology allow 

our products to detect the signal power between the baby unit and parent unit, then automatically reduces 

the emission power from baby unit when the two units are in close vicinity. As a result, the level of radiation to 

baby is greatly reduced and always at the minimal level. Nuvita TULE technology helps to protect the baby’s 

health for now and future.
DECT and 2.4GHz solution are most common wireless technology applied in baby monitor telecommunication. 

DECT is Digital Enhanced Cordless Technology, widely used in household wireless telephones. 2.4GHz solution 

is using the 2.4GHz bandwidth for signal transfer. Both DECT and 2.4GHZ were developed for adult use, then 

apply to baby monitors. Nuvita TULE, True Ultra Low Emission Technology, is Exclusively Developed for Baby 

monitors having in mind that the baby’s health is always our First Priority.

ABOUT NUVITA TULE

NUVITA 3015 TULE STARRY AUDIO BABY MONITOR should not be regarded as a medical device. Premature 

babies or those considered to be at risk should be under the supervision of your doctor or health personnel.
Direct supervision of your baby at a regular interval by a responsible adult is strongly recommended in 

addition to using NUVITA 3015 TULE STARRY AUDIO BABY MONITOR.

WARNING

This baby monitor employs full digital technology with zero interference on standby.
The unit can automatically select free channel or hop to free channel during communication to avoid 

interference from other electronic devices. In addition, thanks to the Automatic Power Reduction System 

(APRS) which senses the signal strength between the baby and parent unit and automatically reduces the 

emission power from baby unit when the two units are in close vicinity. The level of radiation to baby is greatly 

reduced.

DIGITAL TECHNOLOGY AND APRS

POWER SUPPLY

BABY UNIT

Pull up the support lever and slide open the 

battery door in direction as shown. Insert 3 

pieces AAA size (UM-4) alkaline batteries into 

the compartment. Observe correct polarities 

indication. Install back the battery door.

Note: For best performance, do not mix 

use old and new batteries or alkaline and 

rechargeable batteries.

1. Operation from batteries

Содержание 3015 Starry







Отзывы: