24
Network Camera User Manual
motion detection schedule setup (See
※ Configuration of camera and surrounding area
1. Auto-focusing function should not be enabled for line crossing detection.
2. Avoid the scenes with many trees or the scenes with various light changes (like many flashing
headlights). The ambient brightness of the scenes shouldn’t be too low.
3. Cameras should be mounted at a height of 2.8 meters or above.
4. Keep the mounting angle of the camera at about 45°.
5. The detected objects should not be less than 1% of the entire image and the largest sizes of
the detected objects should not be more than 1/8 of the entire image.
6. Make sure cameras can view objects for at least 2 seconds in the detected area for accurate
detection.
7. Adequate light and clear scenery are crucial for line crossing detection.
4.4.4
Intrusion
Intrusion
: Alarms will be triggered if someone or something intrudes into the pre-defined
areas. This function can be applicable to important supervision places, danger areas and
prohibited areas, like military administrative zones, house breaking, scenic high danger areas,
no man’s areas, etc.
Go to Config
→
Event
→
Intrusion interface as shown below.
1. Enable region intrusion detection alarm and set the alarm holding time.
2. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to
3. Click the “Save” button to save the settings.
4. Set the alarm area of the intrusion detection. Click the “Area” tab to go to the interface as
shown below.
