Package
Overview
Installation
1
2
3
4
►
Connecting
Network
Cable
2
1
3
*
1 It
is
recommended
to
install
the
water
-
proof
cap
for
outdoor installation
.
*
2
If
the PoE
switch
is
used
to
power
the
camera
,
DC12V
power supply
is
not
required
.
①
Loosen
the
nut
from
the
main
element.
②
Run
the
network
cable (without
RJ 45
connector) through the
both elements. Then
crimp
the
cable
with
RJ 45
connector
.
③
Connect
the
cable
to
the
hermetic
connector
.
Then
tighten
the
nut
and
the
main
cover
.
Thank you for purchasing our product. There may be several
technically incorrect places or printing errors in this manual.
The updates will be added into the new version of this manual.
We will readily improve or update the products or procedures
described in the manual. The content is subject to change
without notice.
Warning
and
Caution
■
If the product does not work properly, please contact your dealer
or the nearest service center. Never attempt to disassemble the
camera yourself. (We shall not be responsible for any problems
caused by unauthorized repair or maintenance.)
■
Keep away from liquid while in use.
■
In the use of the product, you must be strict compliance with the
electrical safety regulations of the nation and region. When the
product is mounted on wall or ceiling, the device shall be firmly
fixed.
■
Do
not
use
camera
beyond
specified
voltage
range
.
■
Do not drop the camera or subject it to physical shock.
■
Avoid touching the camera lens.
■
If cleaning is necessary, please use clean cloth to wipe it gently.
If the device will not be used for a long time, please cover the lens
cap to protect the device from dirt.
■
Do not aim the camera at the sun or extra bright place.
■
Do not place the camera in extremely hot, cold (the operating
temperature shall be -20˚C~50˚C), dusty or damp locations, and do
not expose it to high electromagnetism radiation.
■
To avoid heat accumulation, good ventilation is required for
operating environment.
■
A few parts of the device shall be replaced regularly according
to their average enduring time. Regular checking is recommended
for all users.
Camera
Quick
start
guide
CD
Plastic
plug
×2
Drill
template
Screwdriver
2 tapping screws PA 4×25
Network Cable
MIC IN Cable
CVBS Cable
Power
Cable
TF Card Slot
Reset
1
2
3
5
6
4
Please make sure that the wall or ceiling is strong enough to
withstand 3 times the weight of the camera. Please install and use
the camera in the dry environment. You'd better install back the lower
dome less than 4 hours after removing it.
①
Drill the screw holes and the cable hole on the wall according to
the drill template.
②
Loosen the screws to remove the lower dome from the camera.
Lower
Dome
1
2
3
4
5
6
DC12V
Netwo
rk Cab
le
∅
4.5
∅
91.36
∅
110
30°
39.4mm
39.8mm
NCT-4M-MV2A Vandal Dome Camera
Quick Start Guide
