33
PROGRAM & OPERATION
6. Move the
Joystick
downward to select
―END ANGLE.‖ Hold down the
SHFT/PGM
key
while moving the Joystick to select the end position. The end position angle should be
larger than start position. Release the
SHFT/PGM
key to complete the selection of the
end position. (Or twist zoom handle or hit zoom button to start PTZ control and hit
the Focus button to stop.)
7. Move the
Joystick
downward to select ―Tilt & Zoom.‖ Set the zoom and tilt angle by
holding down the
SHFT/PGM
key.
8. Move the
Joystick
downward to select direction of rotation.
left/ right to select direction of
9. Move the
Joystick
downward to swap the start and end position. left/ right to swap the
start and end position
10. Select
Save and Exit
by moving the
Joystick
to the right. Press
ESC
to exit the
program without saving.
Pressing the
HOME
or
OFF
button to delete stored data,
000
will be displayed immediately.
1.5 TOUR (or MENU => Functions => Tour, Shortcut: TOUR)
There are 8 programmable Tours. Each Tour consists of up to 8 Preset positions, Patterns,
Scans or other Tours. Using second-level Tours, it can be expanded up to 56 functions in a
single Tour. However tours in the second level Tour will be ignored when called by the first
level Tour. This can be best illustrated by the following example:
If
Tour 01 : Preset 02, Preset 03,Tour 02, Tour 03
Tour 02 : Preset 05, Preset 06,
Tour 04
, Preset 05
Tour 03 : Preset 07, Pattern 01
Tour 04 : Preset 08. Preset 05, Pattern 01
Tour1 executes as follows:
Preset 02
Preset 03
Preset 05
Preset 06
Preset 05
Preset 07
Pattern 01
... (Repeat) ---
Tour 04
in Tour 02 will be skipped in Tour 01
Tour 02 executes as follows:
Preset 05
Preset 06
Preset 08
Preset 05
Pattern 01
Preset 05 … Repeat
(Tour 04 is still valid if called directly from Tour 02.)
Содержание EasyTrak SC-P35N
Страница 1: ......
Страница 18: ...18 INSTALLATION AND CONFIGURATION Figure 11 Termination Diagram ...
Страница 62: ...62 TECHNICAL SPECIFICATIONS Dimension Figure 16 Dimension ...
Страница 64: ......