9
SECTION 5
OPERATING PRINCIPLES
5.1 CONTROL PANEL
Figure 2
01-Speed Display :
This display shows the speed values (RPM or RCF) during programming. It also indicates
accelerating condition, braking condition, power failure condition, open lid condition and the
condition that occurs when Start is pressed while the lid is open by the expressions Acc, br, E
oFF, oPEn, cLoSE Lid, respectively. The error codes that occur in case of any failure condition
are also shown on this display.
02
-
Time Display :
This display shows the time during programming and the run.
03-Lid Key and Led :
This key opens the lid if the led is on. It is active before starting the centrifugation and at the
end of the centrifugation when the audible alarm sounds.
04-Set Key:
This key is used to set the speed and time during programming and to check the RPM or RCF
value during the operation.
05-Pulse Key:
The motor increases to the maximum value of the chosen rotor type and continues to spin on
that speed as long as this key is pressed.
06- Value Increasing Key
:
This key is used to increase the parameter values during programming.
