ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
Hardware Used
5
6
5. Assebmle the flame screen to the upper
support.
Secure the flame screen to the upper support
using 8pcs screw 3/16
”
.
6
.
Assemble the reflector onto the flame
screen.
Screw the 3pcs stud on the flame screen,
put 3pcs washer
Φ
6 onto the top of stud,
then put the reflector onto the stud, secure
them with 3pcs washer
Φ
6 and 3pcs wing
nut.
AA
BB
CC
B
DD
x 3
x 3
x 6
Hardware Used
DD
JJ
x 8
Philips
screwdriver
3/16” Screw
x 1
AA
BB
Wing nut
Washer Φ6
CC
Stud
7
7. Carefully install the glass tube by lifting up
and inserting through the center hole in the
upper plate. Ensure the black silicone ring is
attached to the lower edge of the glass tube
as illustrated. Slide the glass tube through the
hole of the lower plate cover and onto the
middle plate. Check and ensure that the glass
tube is positioned properly and is completely
covering the center hole of the middle plate.
8. Assembly the protective guard.
Hang the hooks of the protective guard onto
the holes in supports.
Secure the protective guards with fixing
brackets with 4pcs 3/16" screws.
To aid in installation
place black silicone
ring on the middle
plate and then
install glass tube.
Ensure the rim of
the glass tube sits
firmly in the black
silicone ring.
WARNING! The black
silicone ring must be in place
prior to operating the heater.
BLACK SILICONE
RING
Hardware Used
8
E
DD
HH
DD
JJ
x 4
Philips
screwdriver
3/16” Screw
x 1
HH
Fixing
Bracket
x 4