ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
4. Attach front panel (F) to front-left leg (J) and front-right leg (I) with bolts (AA) and washer (CC) using hex
screw driver (DD), (see Figure 4).
NOTE:
DO NOT tighten the screws completely.
Hardware Used:
AA Bolts (M6 x 12) x 4
CC Washer (M6) x 4
DD Hex screw driver x 1
Figure 4
J
F
I
DD
AA
CC
5. Attach back panel (C) to back-left leg (G) and back-right leg (H) with bolts (AA) and washer (CC) using hex screw
driver (DD), (see Figure 5).
NOTE:
DO NOT tighten the screws completely.
Hardware Used:
AA Bolts (M6 x 12) x 4
CC Washer (M6) x 4
DD Hex screw driver x 1
Figure 5
H
G
C
DD
AA
CC
6. Attach gas cylinder support (K) to back-left leg (G) and back-right leg (H) and front-left leg (J) and front-right leg (I)
with bolts (BB) and washer (CC) using hex screw driver (DD), (see Figure 6).
NOTE:
Tighten all screws completely.
Hardware Used:
BB Bolts (M6 x 15) x 4
CC Washer (M6) x 4
DD Hex screw driver x 1
I
H
G
J
K
Figure 6
BB
DD
CC
Figure 7
Figure 8
8. Attach the door handle (N) to the door panel (E) with the bolt (EE) using a Phillips screwdriver (NOT included),
(see Figure 8).
Hardware Used:
EE Bolt (M4 x 10) x 1
7. With the help of another person, carefully turn the fire pit to the upright position. Attach the door panel (E) to the
front right leg (I) by aligning the hinge on the door panel with those on the front right leg (I) and inserting the pins in
the hinges, (see Figure 7).
I
E
E
N
CAUTION:
Please be advised that this fire pit is equipped with natural lava rock that may crackle or pop the first time it is
used. The lava rock has been pre-heat treated to release any natural inherent moisture. However, in rare cases on first time
use, the lava rock may pop or burst causing small pieces of hot rock to potentially be a projectile. These hot pieces could
cause injury or property damage. As a precaution, please follow these instructions the first time the fire pit is used:
(1). On first use, do not stand over or near the fire pit once lit.
(2). Light the fire pit and let it run on high for 20 minutes.
(3). Once lit, do not go within 12 feet of the fire pit for at least the first 20 minutes on the first use to ensure
any residual moisture trapped in the rocks gets released.
(4). After the first heating cycle there is little further concern. It is rare that any crackling will happen on the
first use, this is simply a precaution.
(5). Keep lava rock covered and dry while not in use to prevent additional moisture from getting in the rocks.
(6). If lava rocks are exposed to moisture after first use, run the burner on low to gradually warm and dry the
rocks before repeating steps 1 through 3.
9. Open the box of lava rocks, put the lava rocks (L) into the fire bowl of the fire table (B), (see Figure 9). A gas fire
pit requires 6.6 lbs lava rocks.
WARNING:
Keep children away during assembly, as this item contains lava rock, which are small pieces and can
be swallowed by children.
NOTE:
Leave the pilot box uncovered by the lava rock.
Figure 9
pilot box
L
B
