NUTRICHEF PKSTMOVN72, Руководство пользователя

Страница: 10 / 20

www.NutrichefKitchen.com
9
7. When the menu “Roast” is selected, icon is ON. The temperature display
column will show “F-1”, and meanwhile, the time display column will show the
required working time. Press the selection key “ ”, the temperature display
column will show “F-1”, “F-2”, “F-3” … “F-9”.. “F-1”, and repeat this circle, and the
corresponding time column will show the required time. Press the ENTER key, the
machine begins to work and the time begins to count down.
8. When the menu “Bake” is selected, icon is ON. The temperature display
column will show “H-1”, and meanwhile, the time display column will show the
required working time. Press the selection key “ ”, the temperature display
column will show “H-1”, “H-2”, “H-3” … “H-9”.. “H-1”, and repeat this circle, and the
corresponding time column will show the required time. Press the ENTER key, the
machine begins to work and the time begins to count down.
9. When the menu DIY is selected, the “steam” function icon in upper left corner is
ON. Press the selection key “ ”to enter the function selection mode. The display
column at the left side of the screen will show the corresponding function icon,
as shown in the following figure. There are 9 DIY regular function modes. Each
gear of the key corresponds to a function. The key moves a gear, the function icon
will automatically jump down to flash, and the frame will not flash. After the
desired function is selected, it can be confirmed by press the ENTER key
10. When the menu “Descaling” is selected, the icon is ON to remove the scale.
(Working time of 50 minutes is not adjustable. The work process cannot be paused)
3. Setting of working hours and temperature
After the desired function is selected, it shall be confirmed by pressing the ENTER
key to enter the setting of working hours. The hour bit will flash. Press the
selection key to set the hour bit. After it is confirmed by pressing the ENTER key,
the minute bit will flash, and then press the selection key to set the minute bit.
After it is confirmed by pressing the ENTER key, the temperature bit will flash,
and then press the selection key to set the working temperature for “Top heater
pipe” and “Bottom heater pipe”. After the setting of working temperature is
finished, press the ENTER key to start working.
For example, the setting of “Top heater pipe” working mode:
1. Select function
F
°FF