OPERATING INSTRUCTIONS
USING THE APPLIANCE
Step 1:
Ensure to place the appliance onto a stable and heat resistant surface
before operation.
Step 2:
Assemble the air fryer with the stainless steel bowl in place.
Step 3:
Select a suitable accessory according to your cooking requirements and
place inside the bowl.
Step 4:
Place food in the appliance and place the lid on the appliance. Ensure
the lid is fitted correctly by matching the 2 arrow sides together.
NOTE:
Ensure there is adequate space and the food does not touch the
heating element.
Step 5:
Connect the power cord to a suitable wall outlet.
Step 6:
To start the appliance, press the CONFIRM button once, the display
screen will flash. Then press the MENU button, followed by any of the
6 pre-programmed buttons. The display screen will show the remaining
time of the selected program. Press the CONFIRM button again to start
the selected program. At the start of every program, a long beep will
be heard if the lid is placed on top of the base properly. When the
appliance starts to operate, the fan will run and the heating element
will illuminate.
NOTE:
To check the temperature display, press the TEMP button and
the screen will display the temperature. To revert back to time
display, press the TIME button.
Step 7:
When the program is completed, 10 beeps will be heard before the
appliance automatically powers OFF. Remove the lid and serve the food
on your plate.
SPECIAL OPERATION NOTES
1.
When set time elapses, the appliance will automatically stop, However,
the fan may still run for a while until the heat reduces to a lower
temperature. This is to prolong the life of the circuit board and other
components within the appliance.
2.
If you are required to pause the cooking, simply lift off the lid. The
appliance will pause. If you place the lid back on top of the base within 3
minutes, the appliance will continue to operate the same program without
pressing the CONFIRM button. If you place the lid back after 3 minutes,
you will need to re-program.
3.
You can set the time and temperature manually by pressing the CONFIRM
button once, followed by the TEMP button, the display screen will show
60°C as default. Press the increase or decrease button to adjust the
temperature as desired. Then to set the time, press the TIME button, the
6
