Page 3
ALLURE™ WS15 SERIES
RANGE HOOD
PREPARE THE HOOD
PREPARE THE HOOD
5
Remove either
top or back wir-
ing knockout and
install approved
Electrical Cable
Clamp.
DAMPER/DUCT
CONNECTOR
WIRING
COVER
ELECTRICAL CABLE CLAMP
Non-Ducted Installation - Skip to “Connect
Wiring” section.
6
Remove
Light Panel - held in place with (3) #8 screws
and (2) #8 screws. Disconnect light assembly wire harness
(white connector).
(3) #8 SCREWS
LIGHT
PANEL
(2) #8 SCREWS
The following
Steps (6 thru
13) are for
DUCTED
INSTALLATION
ONLY.
BAFFLE
7
Remove
Air
Chute - held in
place with one
(1) screw.
NOTE: Be care-
ful not to discon-
nect any wires.
9
Rotate baffle. Re-
insert baffle into air
chute (as shown) so
that baffle
tabs fit all
the way into
slots in
air chute. An audible
“click” will be heard
when fully installed.
This will close off
the air flow through
the non-ducted slots
on top of hood.
10 Re-install air chute, re-connect wire
harness, and replace light panel.
NOTE: Be careful not to trap wires
between
support fin and light panel.
AIR CHUTE
SLOTS
8
Remove
Baffle
from air chute.
BAFFLE
SUPPORT FIN
TABS
3
Remove
Damper/Duct
Connector
from inside
the hood. Set
connector aside
- with mounting
screws.
4
Remove
Wiring
Cover from inside
the hood. Parts
bag can be found
underneath. Set
cover, mounting
screw and parts
bag aside.