MODEL RCK01
Page 2
5. If other fan or supply wires are different color, have this unit
installed by a qualified electrician.
6. Push all connected wires up into junction box.
7. Reinstall the canopy over the mounting bracket.
8. Restore the electrical power.
OPERATION
1. Install a 9 volt battery (not included).
To prevent damage to the transmitter,
remove the battery if not used for
long periods of time. (Figure 4)
2. Store the transmitter away from
excess heat or humidity.
3. Automatic learning function:
The frequency switches have been
preset at the factory. If you find that your
fan and light kit go on and off without
using your remote control, there may
be interference from other remote
units such as garage door openers,
car alarms or security systems. Reset
the frequency code in your transmitter to a new code setting,
then press and hold the OFF button on the transmitter for
5 seconds (within 60 seconds). The receiver will lock in
the chosen frequency on the transmitter and receiver.
4.
HI, MED, LOW buttons (Figure 5):
These four buttons are used to set the fan speed as follows:
LOW = Low speed, MED = Medium
speed, HI = High speed.
5.
OFF button (Figure 5):
This button turns the fan off.
6.
button (Figure 5):
This button controls light brightness.
Switch the “D” and “ON” dip switch
to decide the light in “ON/OFF” or
“Dimmable” condition (Figure 6).
The “D” selection is the light on only (no
dimming function) and is to be used with
CFL bulbs - as CFL bulbs cannot be
dimmed properly.
The “ON” selection is the
light dimmable selection
and is to be used with all
bulbs except for CFL bulbs.
The light function is
controlled by pressing
the
button. Hold
to increase or decrease
the light. Tap
quickly to turn the light
off or on. If you press
in excess of 0.7 seconds it becomes a dimmer.
The light varies cyclically in 0.8 seconds.
The light key has auto resume, so it will stay at the
same brightness as the last time it was turned off.
TROUBLESHOOTING
FAILS TO OPERATE:
• Power to the receiver?
• Receiver wired correctly?
• Fan manual speed control in highest position?
• Light kit switch turned on?
• Good battery in the transmitter?
• Code set at exact same position in both transmitter and receiver?
WON’T OPERATE AT DISTANCE:
If transmitter operates the fan and the light kit when up close, but not
at 30 feet away, try placing the black antenna wire higher; up through
the ceiling, outside the junction box.
NOTICE
Your ceiling fan and light kit assembly must meet the following
requirements:
• Do not use with solid state fans.
• Electrical rating: 120V / 60 Hz
• MAX. motor amps: 1.0 A
• MAX. light watts: 300W (Incandescent only)
• CAUTION: Ceiling angle shall NOT exceed 30 degrees for mounting
controller.
9
Vo
lt
Ba
tte
ry
FIGURE 4
FIGURE 5
FIGURE 6
WARRANTY
NuTone Ceiling Fans and Accessories
Limited Warranty
WARRANTY PERIOD: NuTone warrants to the original consumer purchaser of its NuTone Ceiling Fans and Accessories
will be materially free from defects in materials or workmanship for a period of one (1) year from the date of original
purchase. This warranty does not cover glass globes or light bulbs provided with the light kits.
The limited warranty period for replacement parts, and for fans repaired or replaced under this limited warranty, shall
continue for the remainder of the original warranty period.
NO OTHER WARRANTIES: THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ANY OTHER
WARRANTIES, EXPRESS OR IMPLIED. NUTONE DISCLAIMS AND EXCLUDES ALL OTHER EXPRESS WARRANTIES,
AND DISCLAIMS AND EXCLUDES ALL WARRANTIES IMPLIED BY LAW, INCLUDING WITHOUT LIMITATION THOSE
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. TO THE EXTENT THAT APPLICABLE LAW
PROHIBITS THE EXCLUSION OF IMPLIED WARRANTIES, THE DURATION OF ANY APPLICABLE IMPLIED WARRANTY
IS LIMITED TO THE PERIOD SPECIFIED FOR THE EXPRESS WARRANTY. Some states do not allow limitations on how
long an implied warranty lasts, so the above limitation may not apply to you. Any oral or written description of the fan
is for the sole purpose of identifying it and shall not be construed as an express warranty.
REMEDY: During the applicable limited warranty period, NuTone will, at its option, provide replacement parts for, or
repair or replace, without charge, any fan or part, to the extent NuTone finds it to be covered by and in breach of this
limited warranty. NuTone will ship the repaired or replaced fan or replacement parts to you at no charge. You are
responsible for all costs for removal, reinstallation and shipping, insurance or other freight charges incurred in the
shipment of the fan or part to NuTone. This warranty does not cover (a) normal maintenance and service, (b) normal
wear and tear, (c) any fans or parts which have been subject to misuse, abuse, abnormal usage, negligence, accident,
improper or insufficient maintenance, storage or repair (other than repair by NuTone), (d) damage caused by faulty
installation, or installation or use contrary to recommendations or instructions, (e) any fan that has been moved from its
original point of installation, (f) damage caused by environmental or natural elements, (g) damage in transit, (h) natural
wear of finish, (i) fans in commercial or nonresidential use, or (j) damage caused by fire, flood or other act of God. This
warranty covers only fans sold in the United States or through U.S. distributors authorized by NuTone.
EXCLUSION OF DAMAGES: NUTONE’S OBLIGATION TO PROVIDE REPLACEMENT PARTS, OR REPAIR OR REPLACE,
AT NUTONE’S OPTION, SHALL BE YOUR SOLE AND EXCLUSIVE REMEDY UNDER THIS LIMITED WARRANTY AND
NUTONE’S SOLE AND EXCLUSIVE OBLIGATION. NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, INDIRECT,
CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH THE FAN, ITS USE OR
PERFORMANCE. Incidental damages include but are not limited to such damages as loss of time and loss of use.
Consequential damages include but are not limited to the cost of repairing or replacing other property which was
damaged if the fan does not work properly.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation
or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights,
which vary from state to state.
This warranty supersedes all prior warranties and is not transferable from the original consumer purchaser.
NUTONE SHALL NOT BE LIABLE TO YOU, OR TO ANYONE CLAIMING UNDER YOU, FOR ANY OTHER OBLIGATIONS
OR LIABILITIES, INCLUDING, BUT NOT LIMITED TO, OBLIGATIONS OR LIABILITIES ARISING OUT OF BREACH OF
CONTRACT OR WARRANTY, NEGLIGENCE OR OTHER TORT OR ANY THEORY OF STRICT LIABILITY, WITH RESPECT
TO THE FAN OR NUTONE’S ACTS OR OMISSIONS OR OTHERWISE.
This warranty covers only replacement or repair of defective fans or parts at NuTone’s main facility and does not include
the cost of field service travel and living expenses.
Any assistance NuTone provides to or procures for you outside the terms, limitations or exclusions of this limited
warranty will not constitute a waiver of such terms, limitations or exclusions, nor will such assistance extend or revive
the warranty.
NuTone will not reimburse you for any expenses incurred by you in repairing or replacing any defective Fan, except for
those incurred with NuTone’s prior written permission.
HOW TO OBTAIN WARRANTY SERVICE: To qualify for warranty service, you must (a) notify NuTone at the address or
telephone number stated below within seven (7) days of discovering the covered defect, (b) give the model number and
part identification and (c) describe the nature of any defect in the fan or part. At the time of requesting warranty service,
you must present evidence of the original purchase date.
Broan-NuTone LLC, 926 West State Street, Hartford, WI 53027 (888-336-6151)
If you must send the fan or part to NuTone, as instructed by NuTone, you must properly pack the fan or part—NuTone
is not responsible for damage in transit.