background image

Page 1

MODEL  QTXEN080C  

WARNING  

  

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR 
INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1.  Use this unit only in the manner intended by the manufacturer. 

If you have questions, contact the manufacturer at the address 
or telephone number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at 

service panel and lock the service disconnecting means to 
prevent power from being switched on accidentally. When the 
service disconnecting means cannot be locked, securely 
fasten a prominent warning device, such as a tag, to the 
service panel.

3. Installation work and electrical wiring must be done by a 

qualifi ed person(s) in accordance with all applicable codes 
and standards, including fi re-rated construction codes and 
standards.

4. Sufficient air is needed for proper combustion and 

exhausting of gases through the fl ue (chimney) of fuel burning 
equipment to prevent backdrafting. Follow the heating 
equipment manufacturer’s guideline and safety standards such 
as those published by the National Fire Protection Association 
(NFPA), and the American Society for Heating, Refrigeration 
and Air Conditioning Engineers (ASHRAE), and the local code 
authorities.

5. When cutting or drilling into wall or ceiling, do not damage 

electrical wiring and other hidden utilities.

6.  Ducted fans must always be vented to the outdoors.
7.  Acceptable for use over a tub or shower when connected to 

a GFCI (Ground Fault Circuit Interrupter) - protected branch 
circuit (ceiling installation only).

8.  This unit must be grounded.

CAUTION  

!

1. For general ventilating use only. Do not use to exhaust 

hazardous or explosive materials and vapors.

2.  To avoid motor bearing damage and noisy and/or unbalanced 

impellers, keep drywall spray, construction dust, etc. off power 
unit.

3. Please read specification label on product for further 

information and requirements.

MODEL QTXEN080C
VENTILATION FAN

READ AND SAVE THESE INSTRUCTIONS

CLEANING & MAINTENANCE

WARRANTY

NUTONE THREE YEAR  LIMITED WARRANTY

NuTone warrants to the original consumer purchaser of its products that 
such products will be free from defects in materials or workmanship for 
a period of three years from the date of original purchase. THERE ARE 
NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT 
NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR 
FITNESS FOR A PARTICULAR PURPOSE.
During this three-year period, NuTone will, at its option, repair or replace, 
without charge, any product or part which is found to be defective under 
normal use and service.
THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP 
STARTERS AND TUBES. This warranty does not cover (a) normal main-
tenance and service or (b) any products or parts which have been subject 
to misuse, negligence, accident, improper maintenance or repair (other 
than by NuTone), faulty installation or installation contrary to recommended 
installation instructions.
The duration of an implied warranty is limited to the three-year period as 
specifi ed for the express warranty. Some states do not allow limitation 
on how long an implied warranty lasts, so the above limitation may not 
apply to you.
NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE’S OP-
TION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY 
UNDER THIS WARRANTY. NUTONE SHALL NOT BE LIABLE FOR INCI-
DENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF 
OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some 
states do not allow the exclusion or limitation of incidental or consequential 
damages, so the above limitation may not apply to you.
This warranty gives you specifi c legal rights, and you may also have other 
rights, which vary from state to state. This warranty supersedes all prior 
warranties.
To qualify for warranty service, you must (a) notify NuTone at the address 
or telephone number stated below, (b) give the model number and part 
identifi cation and (c) describe the nature of any defect in the product or 
part. At the time of requesting warranty service, you must present evidence 
of the original purchase date.

Broan-NuTone Canada Inc.,

 1140 Tristar Drive, Mississauga, ON L5T 1H9

(1-888-882-7626)

Installer: Leave this manual with the homeowner.

For quiet and efficient operation, long life, and attractive 
appearance - lower or remove grille and vacuum interior of unit 
with the dusting brush attachment.

The motor is permanently lubricated and never needs oiling. If the 
motor bearings are making excessive or unusual noises, replace 
the motor with the exact service motor. The impeller should also 
be replaced.

OPERATION

Use an on/off switch or speed control to operate this ventilator. 
See “Connect Wiring” for details.

Содержание QTXEN080C









Отзывы: