background image

Page 1

MODELS QTREN070C • QTREN080C  

WARNING  

  

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR 
INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1.  Use this unit only in the manner intended by the manufacturer. 

If you have questions, contact the manufacturer at the address 

or telephone number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service 

panel and lock the service disconnecting means to prevent 

power from being switched on accidentally. When the service 

disconnecting means cannot be locked, securely fasten a 

prominent warning device, such as a tag, to the service panel.

3. Installation work and electrical wiring must be done by 

quali

fi

 ed personnel in accordance with all applicable codes 

and standards, including 

fi

 re-rated construction codes and 

standards.

4. Suf

fi

 cient air is needed for proper combustion and exhausting 

of gases through the 

fl

 ue (chimney) of fuel burning equipment 

to prevent backdrafting. Follow the heating equipment 

manufacturer’s guideline and safety standards such as those 

published by the National Fire Protection Association (NFPA), 

and the American Society for Heating, Refrigeration and 

Air Conditioning Engineers (ASHRAE), and the local code 

authorities.

5. When cutting or drilling into wall or ceiling, do not damage 

electrical wiring and other hidden utilities.

6.  Ducted fans must always be vented to the outdoors.
7. Acceptable for use over a tub or shower when connected to 

a GFCI (Ground Fault Circuit Interrupter) - protected branch 

circuit (ceiling installation only).

8.  This unit must be grounded.
9. When applicable local regulations comprise more restrictive 

installation and/or certi

fi

  cation requirements, the aforementioned 

requirements prevail on those of this document and the installer 

agrees to conform to these at his own expenses.

10. When performing installation, servicing or cleaning this unit, it 

is recommended to wear safety glasses and gloves.

CAUTION  

!

1. For general ventilating use only. Do not use to exhaust 

hazardous or explosive materials and vapors.

2. This product is designed for installation in ceilings up to a 12/12 

pitch (45 degree angle). Duct connector must point up. DO 

NOT MOUNT THIS PRODUCT IN A WALL.

3.  To avoid motor bearing damage and noisy and/or unbalanced 

impellers, keep drywall spray, construction dust, etc. off power 

unit.

4.  Please read speci

fi

 cation label on product for further information 

and requirements.

MODELS QTREN070C 
& QTREN080C VENTILATION FANS

READ AND SAVE THESE INSTRUCTIONS

CLEANING & MAINTENANCE

Installer: Leave this manual with the homeowner.

For quiet and efficient operation, long life, and attractive 

appearance - lower or remove grille and vacuum interior of unit 

with the dusting brush attachment.

The motor is permanently lubricated and never needs oiling. If the 

motor bearings are making excessive or unusual noises, replace 

the motor with the exact service motor. The impeller should also 

be replaced.

OPERATION

Use an on/off switch or speed control to operate this ventilator. 
See “Connect Wiring” for details.

BB0007

WARRANTY

BROAN-NUTONE CANADA INC.

THREE-YEAR LIMITED WARRANTY

Broan-NuTone Canada warrants to the original consumer purchaser of its products that 

such products will be free from defects in materials or workmanship for a period of three 

(3) years from the date of original purchase. THERE ARE NO OTHER WARRANTIES, 

EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES 

OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

During this three-year period

, Broan-NuTone Canada will, at its option, repair or 

replace, without charge, any product or part which is found to be defective under 

normal use and service.
THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS 

OR TUBES, BULBS OR BATTERIES, FILTERS, DUST, ROOF CAPS, WALL 

CAPS AND OTHER ACCESSORIES FOR DUCTING. This warranty does not cover 

(a) normal maintenance and service or (b) any products or parts which have been 

subject to misuse, negligence, accident, improper maintenance or repair (other than by 

Broan-NuTone Canada or an authorized representative), faulty installation or 

installation contrary to recommended installation instructions.
The duration of an implied warranty is limited to the three-year period as speci

fi

 ed for 

the express warranty.
BROAN-NUTONE CANADA’S OBLIGATION TO REPAIR OR REPLACE, AT 

BROAN-NUTONE CANADA’S OPTION, SHALL BE THE PURCHASER’S SOLE AND 

EXCLUSIVE REMEDY UNDER THIS WARRANTY. BROAN-NUTONE CANADA 

SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL 

DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR 

PERFORMANCE. This warranty supersedes all prior warranties.
To qualify for warranty service, you must (a) notify Broan-NuTone Canada at the address 

or telephone number stated below, (b) give the model number and part identi

fi

 cation and 

(c) describe the nature of any defect in the product or part. At the time of requesting 

warranty service, you must present evidence of the original purchase date.

Date of Installation _______________ Builder  or  Installer __________________________

Model Number and Product Description  _______________________________________

IF YOU NEED ASSISTANCE OR SERVICE:

For the location of your nearest Broan-NuTone Canada Inc. dealer

Dial Toll Free: 

1-888-882-7626

Please be prepared to provide:

Product model number • Date and proof of purchase • The nature of the dif

fi

 culty

Broan-NuTone Canada Inc.

1140 Tristar Drive, Mississauga, Ontario L5T 1H9

Register your product 

online at www.nutone.ca

Содержание QTREN070C









Отзывы: