2
MOUNTING THE HOUSING
1. Locate housing between joists.
2.
Refer to Figure 5.
Using nails, secure hanger bars to joist.
NOTE: The hanger bar brackets are adjustable.
Allowing for the thickness of the finished ceiling,
mount hanger bars so that edge of housing will be
flush with the finished ceiling.
3. Adjust brackets as required. Tighten brackets.
INSTALLATION IN
NEW CONSTRUCTION
PREPARATION
1. Loosen hanger bar brackets to allow bars to be inserted.
2.
Refer to Figure 2.
Insert hanger bars into brackets.
3.
Refer to Figure 3.
Slide hanger bar brackets down to end
of slot closest to outside edge of housing. Tighten brackets
in this position.
4.
Refer to Figure 4.
Remove junction box cover by
removing one screw.
5.
Refer to Figure 4.
Remove appropriate wiring knockout(s)
and install approved box connector(s).
FIGURE 2
FIGURE 3
FIGURE 4
HANGER BARS
ADJUSTMENT
SLOT
JUNCTION
BOX
COVER
KNOCKOUTS
FIGURE 5