A
Ensure all fasteners (bolts/washers) are securely tightened and all
chair parts have been assembled correctly (Refer back to Assembly
Instructions if needed. Contact Nuprodx, Inc. if unsure of anything).
B
Place the assembled tub section of the slider into the desired
position of the bath tub (Refer to Figure 10).
C
Position the assembled commode section of the slider next to the
outside wall of the bath tub (Refer to Figure 11).
D
Adjust the height of the tub section to match the height of the
commode section by either adjusting the four inner legs (tub section)
and/or the adjustable crutch tips (tub section) - Refer to Figure 12.
E
Insert the connector bridge into the four eyelet holes (Two located
on the commode section and two located on the tub section) - Refer
to Figure 13. Switch the four shoulder screws to the lock position on
the connector bridge (Refer to Figure 14).
F
Release the latch mechanism on the commode section and slide
the slider seat assembly onto the tub section, making sure the latch
engages fully and locks in place. If the commode section and tub
section are not level in height or out of alignment, the slider seat
assembly will not function correctly and safely. To ensure the safety
of the user, make adjustments to both sections as needed and retry
Step F (Refer to Figure 15).
G
Remove the connector bridge to test the stability of the tub sec-
tion. Also, ensure that the slider seat frame is locked into place and
will not remove during use. Once this is complete, replace the con-
nector bridge and slide the slider seat frame back to the commode
section. The connector bridge can then be removed and the chair is
ready for use.
OPERATING INSTRUCTIONS
- PAGE 4 -
Figure 14
Figure 15
Figure 10
Figure 12
Figure 13
Figure 11
Inner Leg
Adjustment
Crutch Tip
Adjustment
