NuPrime HD-AVA, Руководство пользователя

Страница: 14 / 51

NuPrime
13
1. Two-channel linear PCM (32-192 kHz, 16/20/24 bit)
2. Multi-channel linear PCM (up to 7.1 channels, 32-192 kHz, 16/20/24 bit)
3. Bit stream: DOLBY DIGITAL, DOLBY DIGITAL Plus, DOLBY TrueHD, DTS, DTS-HD
High Resolution Audio, DTS-HD Master Audio. Your DVD / BD players must
support HDMI output of the above audio formats.
5.1.1. HDMI ARC Function:
ARC Mode: Audio Return Channel (ARC) enables an ARC-enabled TV to send audio data to
HD-AVA/AVP without via extra external audio signal connection such as optical or coaxial.
Only HDMI Output 1 supports ARC function.
To setup ARC: Go to Audio Setup (OSD) menu > Setup > Input Config > Input Setup. Under
TV option, you can set the Audio option to HDMI ARC to enable ARC function. (See OSD
menu setup for detail explanation. See page 38)
5.1.2. HDMI CEC Function:
Consumer Electronics Control (CEC) is a set of commands that utilizes HDMI’s two- way
communication to allow for single remote control of any CEC-enabled devices connected
with HDMI. A CEC command will trigger the necessary commands over HDMI for an entire
system to auto-configure itself to respond to the command. When devices that support
HDMI Control (CEC) are connected, the following modes of operation can be executed via
the HD-AVA/AVP or the external device using any of the device’s remote control.
To Setup CEC: Go to Audio Setup (OSD) Menu > Setup > Option > Under HDMI CEC Control.
(See OSD menu setup for detail explanation. See page 42)
5.1.3. HDMI Off Through Function:
Enable audio signal remain functional through HDMI outputs even when HD-AVA/AVP is on
standby.
To Setup Off Through function: Go to Audio Setup (OSD) Menu > Setup > Option > Under
HDMI OFF Through. Default sets to OFF. (See OSD menu setup for detail explanation. See
page 42)
5.2. Digital Audio connection: