NUOVA ELETTRONICA DSP LASER AP, Инструкция по эксплуатации

Страница: 67 / 106

DSP LASER AP with MCS
B2
1P ,2P N, 2P M, 2P N
CNC, 2P M CNC
Maximum number of Foot Pedal Controls used
and their function:
1P: one Pedal
2P N: two Foot Pedal Controls in Normal mode
2P M: two Foot Pedal Controls in Master/Slave
mode
2P N CNC: two Foot Pedal Controls in Normal
mode with selection via RS232
2P M CNC: two Foot Pedal Controls in Master/
Slave mode with selection via RS232.
B3 AUTO/MANUAL
Activation state of Automuting function.
AUTO: Automuting function is active.
MANUAL: only the top area of the receiver is
activated and must be placed at SA+5mm from
the tool tip with a proper adjusting instrument to
require at the order. This function is active only
with the use of DSP AP, cannot be used when
using the DSP Laser or a photoelectric barrier
for the front protection of the operator.
B4 RST AUTO/RST UP P
Indicates if the reset of the Antipanic is
automatically executed releasing the pedal
(RST AUTO) or pressing the Upstroke pedal
(RST UP P).
B5 A, B, A CNC, B CNC
Type of Blanking used in Mode2.
A: Operator Enabling.
B: Stop&Go.
A CNC and B CNC: the Mode selection is made
by CNC via RS232.
B6 SINGLE/DOUBLE
Type of used inputs depending on the used
Rear Guard.
SINGLE: Only one pulsed input (INP7)
connected through one NC contact to the
relevant pulsed output OUTP7.
DOUBLE: Two pulsed inputs (INP7 and INP8)
connected through two NO contacts to the
relevant pulsed outputs OUTP7 and OUTP8 or
equivalent.
B7 OFF, ON, ON CNC
Enabling state of the Upper and Lower Clamp
function.
OFF: Clamp Control Function disabled.
ON: Clamp Control Function enabled.
ON CNC: Clamp Control Function enabled with
Clamp command sent by CNC via RS232.
B8 OFF, ON, ON CNC
Enabling state of the Hemming upstroke control
function.
OFF: Hemming upstroke Control Function
disabled.
ON: Hemming upstroke Control Function
enabled.
ON CNC: Hemming upstroke Control Function
enabled with activation command sent by CNC
via RS232.
DLAM01EN 61