Nuna pipa urbn, Инструкция по эксплуатации

Страница: 25 / 32

46 PIPA urbn instructions 47 PIPA urbn instructions
Using Vehicle Lap/
Shoulder Belt
Only install in a forward facing
vehicle seat.
1
- Position child restraint so that child
is facing the rear of the vehicle.
2
- Option 1 (Preferred): Route the
vehicle lap belt under both lap
belt guides. Then route the
shoulder belt around the back of
the child restraint passing through
the blue shoulder belt guide.
Option 2: Route the vehicle lap
belt under both lap belt guides
and buckle the vehicle belt.
Allow shoulder belt to lay against
vehicle seat back as shown.
3
- Adjust the angle of the child
restraint. A rolled up towel or foam
pool noodle may be used to adjust
the amount of recline.
4
- Angle is correct when blue line
on child restraint (located on
the label on the side of the child
restraint) is level with ground.
5
- Tighten vehicle belt while pushing
child restraint firmly into vehicle
seat. Remove all vehicle belt slack
around belt guides and feed belt
into vehicle belt retractor.
Lock
or switch vehicle belt to locked
mode . Refer to vehicle owner’s
manual for instructions. If you
cannot lock the vehicle belt, you
must use a locking clip (p.52).
2
1 3
4
5
Option 1
Option 2
(preferred)
See p. 50 for final belt install steps.