Please take care when unpacking this appliance as some of the parts may be heavy.
1)
Lift out the top fitting complete with all accessories and place to one side.
2)
Lift out middle fitting and place to one side.
3)
Lift off head assembly complete with mains cable and place onto the floor.
4)
Lay the main packaging box down and gently slide the drum assembly out of
the packaging, ensure the drum assembly is upright once out of the box.
5)
Fit head assembly onto drum assembly and secure in place using the hooked
knobs fitted to the drum assembly.
Please ensure the following items been included;
•
1 x WVDP 1800-2 PH Pond Vacuum
•
1 x 1800 drum handle assembly
•
1 x 601101 2.5mtr hose
•
1 x 601027 Stainless Steel bend
•
1 x 601328 Pick up nozzle with blades(for working on the pond floor)
•
1 x 601428 Pick up nozzle with brushes (for removing blanket weed from the
pond floor)
•
1 x 601141, 1 x 601145, and 1 x 601146 accessory kit (for cleaning the pond
sides)
•
4 x 601008 Stainless Steel Extension Tubes
Important Note
Before using this vacuum around the pool side, it is strongly recommended that an R.C.D unit is
fitted in between the mains plug from the vacuum and the wall socket.
Instructions:
1.
Connecting the machine together:
•
Fit drum handle into the slots on the sides of the drum assembly, use a pozi drive
screwdriver to remove the pozi screws before fitting the handle. Refit screws and
tighten once the handle is in place.
•
Connect the vacuum hose to the hose flange on the front of the vacuum.
•
Assemble the wand sections and connect to the vacuum hose.
•
Fit either the pick up nozzle with blades/ brushes to the wand section.
•
Uncoil the dump hose assembly on the rear of the vacuum into a suitable drain or
onto the garden, the hose is 3 metres in length)
•
Open the slide valve on the curved wand section fully.
•
Connect the vacuum to the mains power supply ensuring an R.C.D is fitted
between the mains plug and mains socket.
WVDP 1800-2 Pond Vac
Operator Instructions
