Numatic RSB 140, Оригинальное руководство пользователя, Страница: 11 / 16

Important Warnings - Charger
Read all these warnings before using the charger.
• CAUTION! Charge only Numatic Lithium-Ion batteries, other types of batteries may burst causing
personal injury and damage.
• Check the mains cord regularly for any sign of damage.
• Do not use damaged devices.
• If the mains cord of the charger is damaged, it must be replaced by an original
NUMATIC INTERNATIONAL cord available from the manufacturer or service agent.
• Protect the charger against moisture and store it in a dry place.
• Do not use the charger if it is wet.
• Do not charge below 0°C.
• The mains voltage available must correspond to the voltage stated on the rating plate of
the charger.
• Do not operate charger in explosive environment.
• Do not carry the charger by holding the mains cord.
• Do not handle the electrical cord or plug, with wet hands.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
• Do not cover the charger.
• Do not open the charger. Repairs shall be done only by authorised personnel.
• Do not charge damaged batteries.
• Do only charge dry batteries.
• Do not charge non-rechargeable batteries in this charger.
• The appliance is not intended for use by children or infirmed persons without supervision.
Warning: The battery included in this product must only be charged by the Numatic Charger and docking
system supplied with the product and in NO circumstances should an alternative non Numatic charger be
used as there is risk severe damage and fire could result.
Instructions for Use - Charging Batteries
The charger is intended for use only on flat surfaces, place horizontally on floor or work suface.
The charger is intended for use with the detachable power cord supplied, the power unit is capable of
operating at different voltages without user adjustment.
If the charger is damaged or does not charge anymore, please return to service centre.
Charging Procedure:
1. Ensure the battery is fully inserted into the charger.
2. Fit the mains power cord to charger and suitable power supply.
3. Please Note: If the battery is above its optimum charging temperature (due to ambient
temperature or it if was recently discharged) the charger LED will illuminate on/off RED for a
maximum of 40 minutes whilst the battery temperature falls to an acceptable level for charging to
begin.
4. The LED should show RED to indicate charging.
5. Once fully charged the LED will show GREEN.
6. If power is supplied to the charger with no battery fitted the LED will show GREEN to
indicate STAND-BY status.
Hazards
Health Hazards (Acute & Chronic).
The chemicals used in the battery are in a sealed container.
Risk of exposure only occurs if the battery is abused or damaged.
Contact of electrolyte and lithium with skin and eyes should be avoided.
Signs & Symptoms of Exposure.
A damaged or leaking battery can cause chemical burns upon contact.