Numatic HT4045, Инструкция по эксплуатации

Страница: 9 / 40

Machine Set Up
9
T 01460 68600
Fitting the Floor-tool
The floor-tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off feature if the
floor-tool gets snagged, whilst in transit.
Note:
It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
Note:
Raise floor-tool again before driving to the cleaning area.
Raise the floor-tool for transit or lower for cleaning operation using the lifting
handle fitted to the back of the machine (Fig.11).
For fitting the floor-tool blades (See Page 30).
Fit the floor-tool and retain using
the detent pin (Fig.9).
The lifting strap is held by a
detent pin (Fig.10).
9
10
11
Refit vacuum hose to the Floor-tool when finished.
The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum is switched off.
If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you resume operation (Fig 12-15).
Fitting the Hose Guide
Note:
DO NOT push the vacuum hose onto the Floor-tool with the
Floor-tool in the raised position.
30mm
MAX
12 13 14 15